64
Error
condition
Error code
Error description and possible diagnosis
Err
E0.6
WATER COOLER MISSING
NON automatic reset error.
Check that the WATER COOLER SYSTEM - OBLIGATORY function is included within the
ADVANCED SETUP Menu
/
EQUIPMENT LAYOUT
.
After this initial check you need to know that this error can only occur in the following cases:
• Water cooler system not connected to the welding machine.
• The welding machine does not recognise the water cooler system, even though it is connected
correctly.
• Water cooler system disconnected when the machine is operating normally.
Once the water cooler system has been reactivated, this error condition
resets itself
automatically
!
If the alarm occurs even when the WATER COOLER SYSTEM - OPTIONAL function is included in
the
ADVANCED SETUP Menu
/
EQUIPMENT LAYOUT
,
call Technical Assistance Department
immediately
.
Err
E0.7
MOTOR FAULT
NON automatic reset error.
Immediately contact technical assistance dept.
Error visible on
VISION S
CREEN
ONLY in the event of a fault and NOT in the
ERROR LOG Menu
.
Err
E0.8
WIRE FEEDER MISSING
NON automatic reset error.
Check that the WIRE FEEDER - OBLIGATORY function is included within the
ADVANCED SETUP
Menu
/
EQUIPMENT LAYOUT
.
After this initial check you need to know that this error can only occur in the following cases:
• Wire feeder not connected to the welding machine.
• The welding machine does not recognise the wire feeder, even though it is connected correctly.
• Wire feeder disconnected when the machine is operating normally.
Once the wire feeder has been reactivated, this error condition
resets itself automatically
!
If the alarm occurs even when the WIRE FEEDER - OPTIONAL function is included in the
ADVANCED SETUP Menu
/
EQUIPMENT LAYOUT
,
call Technical Assistance Department
immediately
.
Err
E0.9
CAN INTERNAL ERROR
Faulty communication between the generator and the feeder.
NON automatic reset error.
Error visible on
VISION S
CREEN
ONLY in the event of a fault and NOT in the
ERROR LOG Menu
.
Err
T°C
THERMAL PROTECTION
The welding stops due to an excessively high temperature (thermostat activated).
Automatic reset error.
Err
H20
COOLER PRESSURE
The fluid in the cooling system is at low pressure.
NON automatic reset error.
Err
E1.0
CONFIG. FILE MISSING
NON automatic reset error.
Immediately contact technical assistance dept.
Error visible on
VISION S
CREEN
ONLY in the event of a fault and NOT in the
ERROR LOG Menu
.
Err
E1.1
USER FILE MISSING
NON automatic reset error.
Immediately contact technical assistance dept.
Error visible on
VISION S
CREEN
ONLY in the event of a fault and NOT in the
ERROR LOG Menu
.
Err
E1.2
TORCH FILE MISSING
NON automatic reset error.
Immediately contact technical assistance dept.
Error visible on
VISION S
CREEN
ONLY in the event of a fault and NOT in the
ERROR LOG Menu
.
Err
E1.3
CALIBRATION FILE MISSING
NON automatic reset error.
Immediately contact technical assistance dept.
Error visible on
VISION S
CREEN
ONLY in the event of a fault and NOT in the
ERROR LOG Menu
.
Err
E1.6
MMA DEFAULTS MISSING
NON automatic reset error.
Immediately contact technical assistance dept.
Error visible on
VISION S
CREEN
ONLY in the event of a fault and NOT in the
ERROR LOG Menu
.
Err
E1.7
TIG DEFAULTS MISSING
NON automatic reset error.
Immediately contact technical assistance dept.
Error visible on
VISION S
CREEN
ONLY in the event of a fault and NOT in the
ERROR LOG Menu
.
(continued)