RITUALCARE 2000 SUMMER WAVES
36
35
ENGLISH
2. BEFORE USE
- Take the product out of the box.
- Remove all packaging material. Save the original box.
- Make sure all parts and components are included and in good
conditions. If any visible signs of damage are observed, contact
the Technical Support Service immediately.
3. OPERATION
Note
Only use the wave iron on hair that is at least 80% dry.
ENGLISH
1.
PARTS AND COMPONENTS
Img
. 1
(Page 41)
1.
Cool tip
2.
Top plate
3.
Lower plate
4.
Heating cylinder
5.
Temperature increase button
6.
Temperature reduction button
7.
On/off button
8.
Temperature indicator lights
9.
Plates lock button
10.
Hanging ring
11.
Power cord
For surf waves
1. Select a hair section, 5-cm wide and 1-cm thick approx. Hold the
hair straight with one hand, insert it closest to the root between
the plates of the iron and, holding the iron with the other hand,
close it and hold it for a few seconds.
2. Repeat this step with the rest of the tuft until you reach the tip.
3. Repeat with the rest of the hair.
4. Wait until hair cools down and comb it.
For smooth curls
5. Select a hair section, 5-cm wide and 1-cm thick approx. Hold
the hair straight with one hand, insert it between the plates of the
iron and holding the iron with the other hand, twist the iron, rolling
Plug the device into a power supply.
Place the appliance on a flat, stable and dry surface.
Press the on/off button to switch on the iron.
The hair straightener will indicate the default temperature is
160 ºC.
Press the temperature increase button repeatedly to increase the
temperature in increments of 20°C up to the maximum, 200°C. To
lower the temperature, press the temperature reduction button
repeatedly until the minimum temperature, 160°C, is reached.
The temperature indicator will blink while the device preheats.
Once it has reached the set temperature, the indicator will remain
steady.
