ENGLISH
14
3D FORCEANODIZED 850 I-PUMP
STEAM BURST
By pressing the steam-burst button, an intense burst of steam is emitted from the soleplate.
This function can only be activated during high-temperature ironing.
Note:
to prevent the soleplate from leaking, do not keep the steam-burst button pressed for
more than 5 seconds.
Note:
for optimal steam burst, do not press the steam-burst button more than three times in a
row to prevent the iron from cooling.
SPRAYING
•
As long as there is enough water in the water tank, you may use the spray button at any
temperature setting.
SENSOR TOUCH
The iron includes a touch sensor in its handle. For safety reasons, it will only produce continuous
steam when it is held horizontally by the handle.
PRESSURE-GENERATING PUMP
The iron includes a pressure pump to produce maximum steam and removes the most difficult
wrinkles. To activate it, press once the i-PUMP button located on the product’s top part. During
operation, the LED will light and it will produce a slight sound. To turn it off, press the button and
wait until the light turns off.
SELF CLEANING
•
Make sure the appliance is unplugged.
•
Set the steam knob to “0”.
•
Fill the water tank up to the maximum mark and close it.
•
Set the temperature knob to maximum.
•
Connect the appliance to the power supply.
•
Unplug the appliance when it reaches the temperature.
•
Holding the iron horizontally, press the self-cleaning button.
•
Boiling water and steam will be ejected from the soleplate’s holes, taking out all impurities.
•
Repeat this process if considered necessary.
Tip:
carry out the self-cleaning cycle once every 2 weeks. When excessive limescale is observed,
carry it out more frequently.
AUTO-OFF FUNCTION
The iron will automatically turn off when it is placed and kept still horizontally 25 seconds,
05104_3D ForceAnodized 850 i-Pump_Manual_DS.indd 14
19/12/18 14:03
