ENGLISH
16
3D FORCEANODIZED 850 I-PUMP
6. TROUBLESHOOTING
Problem
Possible cause
Solution
Not enough or too much
heat.
The temperature knob is
not set correctly or it is
unplugged.
Set the temperature knob
to the correct position.
No steam or leakage.
The temperature knob has
been set to MIN.
Steam burst or vertical
steam do not work properly.
The steam-burst function
has been used too often
within a very short period.
The iron is not hot enough.
Continue ironing in
horizontal position and
wait a few minutes before
using the vertical steam-
burst function again.
Water leaks from the
soleplate.
The iron is not hot enough.
Wait until the red light
indicator turns on.
Water is over the max mark.
Empty the left-over water.
Little steam.
Steam holes are blocked.
Clean the hole with distilled
water.
Too little water in the water
tank.
Add water to the water
tank.
Spray does not work
properly.
Not enough pressure or air
inside.
Press the spray nozzle
manually and press the
spray button several times
in a row.
7. TECHNICAL SPECIFICATIONS
Model: 3D ForceAnodized 850 i-Pump
Reference No: 05103
3100 W, 220-240 V, 50/60 Hz
Made in China | Designed in Spain
8. DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European directive 2012/19/EU on Waste Electrical and Electronic Equipment
(WEEE), specifies that old household electrical appliances must not be disposed of with
the normal unsorted municipal waste. Old appliances must be collected separately, in
05104_3D ForceAnodized 850 i-Pump_Manual_DS.indd 16
19/12/18 14:03
