33
Conga WinDroid 970
Light status indicator
Blue light flashing
Ready, you can put the product on glass.
Blue light bright
Ready, product suction is successful, it remains attached to window
and it can start cleaning the window.
Red light flashing
Power adapter is not connected or vacuum is not enough. If the cord is
unplugged and the product starts beeping, remove the product from
the window or plug it again to a power supply.
6. TROUBLESHOOTING
REF. Nº
ERROR
REASON
SOLUTION
1
If the blue light flas-
hes, the robot is
checking that con-
ditions are proper to
work. If this process
takes longer than 20
seconds, it can be
due to any of these
three errors.
Mops are not ins-
talled
correctly
Remove the cleaning mop and
install it again to make it flat.
Free fall sensor error
Check if the free fall sensor has
any foreign matter that stops it
from working properly.
The glass surface is
too dirty
Clean an area first to make the
product stick on the glass.
2
Red light flashing
and beeps warning
Power adapter not
connected
A. Connect to the power supply
first, and press Start to make the
product work again.
B. In case of power cut, use re-
mote control to direct the product
to the place where safely reach it
and remove it.
There is some risk when using
remote control under power cut,
please make sure that highest sa-
fety precautions are taken.
