cecotec 05521, Instruction Manual

FAST&FURIOUS 5010 VITAL

FAST&FURIOUS 5010 VITAL

27

26

Maximum temperature (steam).

Insert the power plug into the wall socket. The light indicator will turn on.
Once the indicator light turns off, the iron is ready to be used.

Filling the water tank
Unplug the iron before filling the water tank.
Hold the steam iron in horizontal position.
Slowly pour water through the water filling opening. Do not exceed the Max. mark on the water 
tank in order to avoid water from spilling.
Close the filling opening while operating the iron.
Empty the water tank after each use.

Note: Do not use chemically descaled or perfumed water.

Spraying
The spraying function can be used at any temperature during steam ironing or dry ironing, 
provided that the water tank is full. 

Steam ironing 
While the appliance is unplugged, fill the iron with water. 
Stand the steam iron on its heel rest in an upright position on an iron-safe surface and connect 
it to the power supply.  
Set the temperature knob to the “••“ or “•••” position.
Set the steam knob to the desired position.
When finished, turn the temperature knob anticlockwise to the minimum position and unplug 
the appliance from the power supply.

Warning: Do not come into contact with the ejected steam.

Dry ironing
The steam iron can operate with or without water in the water tank. In case the iron is operated 
in its dry mode, make sure the water tank is empty.
Turn the steam knob to “0” position.

Warning: If the iron has been used during more than 10 minutes and it is hot, do not pour more 
water inside it until the appliance has cooled down.

Steam burst
The steam-burst function generates additional steam in order to remove stubborn creases 
and can be activated just by pressing the steam-burst button.

Note: To prevent the soleplate from leaking, do not keep the steam burst button pressed for 
more than 5 seconds.
Note: For optimal steam burst, do not press the steam burst button more than three times in a 
row to prevent the iron from cooling.

Vertical steaming
Ensure there is enough water in the tank.
Stand the steam iron vertically, rest it on its heel and connect it to the power supply.
Turn the temperature and steam knob to maximum.
Hold the iron vertically and press the steam burst button, an intense steam will be ejected 
from the soleplate.

Self-cleaning 
Fill the water tank up to the maximum mark and close it. 
Set the temperature knob to maximum. 
Connect the appliance to the power supply. 
Holding the iron horizontally over the sink, turn the steam knob to the maximum position and 
press the self-clean button.
The soleplate will emit boiling water and steam to remove all impurities.
Repeat this process if necessary.

Anti-drip function
This function prevents water from spilling and avoids blotches from appearing on the fabrics 
when ironing at low temperatures.

Anti-calc function
This function protects the iron from scale formations.
Do not use abrasive cleaners or scouring pads to clean the product.

Protection against overheating
The iron features a security system against overheating. The device turns automatically off. 
The soleplate may take up to 45-60 minutes to cool completely down. 

4. CLEANING AND MAINTENANCE

Turn off, unplug the appliance from the power supply, empty the water tank (do it after each 
use) and allow it to cool down completely.  
Do not use abrasive cleaners or scouring pads to clean the product.  
Wind the cord around the heel rest.  
To protect the soleplate while it is stored, place the steam iron in an upright position on its 
heel rest.  

ENGLISH

ENGLISH