cecotec 05551 Instruction Manual Download

Page: 21 / 74

ENGLISH

Warnings:
The Wi-Fi name and password cannot exceed 32 bits.
If the network configuration fails to connect, follow the steps below:
Press the power button for 5 seconds, the robot will enter sleeping mode and the Wi-Fi
light indicator will blink fast indicating connection error. Retry connecting the robot again
following the steps in the before section.

If the connection fails again, check if:
The robot is too far away from the router.
The Wi-Fi password is incorrect.

Function
Pause
During robot operation, press pause on the App to stop it, and press clean to resume cleaning.

Standby
The robot will automatically enter standby mode after 5 minutes of no operation.
Press clean on the App to activate it again.

Note:
After 12 hours of no operation, the robot will turn automatically off.
The robot will not enter standby mode during charging.

Suction power level
Press the suction power level function on the App to set the desired power level.
Choose between Eco (low power), Medium (medium power) and Turbo (high power).

Schedule
The robot is provided with a schedule function in order to provide a maximum-efficiency
cleaning. The time settings and the cleaning scheduling must be carried out from the App.
Once the robot has been scheduled, it will automatically carry out the cleaning cycles every
scheduled day.

Note: Make sure the robot is activated and that the light indicator is lighted before scheduling
any cleaning or setting time.
Light indicator:
Operating: Steady blue light
Low power: Orange light blinks slowly
Charging: Orange light oscillates
Network configuration: Blue light blinks slowly
Start-up/firmware update: Blue light oscillates
Error: Red light flashes quickly

Modes
The first time the robot is operated, it will map and save the whole house’s map by means of
its laser before starting the cleaning cycle. Use the robot in Auto mode and Eco power level,
this way you will ensure the robot memorizes the full map.

Note: Make sure the light indicator is lighted in blue before starting cleaning, indicating it is
activated. If not, press any button on the App to activate it.

Auto mode
Fig. 14.
Press the Auto mode button on the App for it to start cleaning automatically, first a cleaning
cycle in Edge mode and then another cycle in and organized zigzag motion, recognizing which
areas it has cleaned and which ones it has not. The robot will automatically plan the cleaning
route as it is cleaning. If during this mode the robot is controlled manually, the robot will
calculate the route again and could go through previously cleaned areas. In order to ensure
efficient cleaning, do not operate it manually during auto mode cleaning.

Thanks to its Total Surface 2.0 technology, if the battery is low during the cleaning cycle, the
robot will smartly return to the charging base automatically and, once it is fully charged, it
will resume the cleaning process from the same point, offering a high-efficiency cleaning.
During cleaning, the robot will stop briefly to evaluate the area and calculate the cleaning
route (this stop will vary depending on the house conditions).

Note: The robot cleans in an organized way and per 4x4 m squared areas, therefore it might
leave the room where it is cleaning to finish off the delimited area. Do not worry, the robot
will clean all the accessible surface.

Edge mode
Fig. 15.
Press the Edge mode button on the App for the robot to start cleaning along the edges. It
will automatically start cleaning along all the surface’s perimeters and then will return to
the charging base direct and automatically. If the robot has not started cleaning from the
charging base, it will return to the starting point.
Note: Press the power levels button to switch between the 3 modes: Turbo/Normal/Eco.

Back home mode
Fig. 16.
Press the back home button on the App in order to send it to the charging base. This function
can be activated during any other cleaning cycle and the robot will automatically return to the
charging base and stop the cleaning process. The robot will take the shortest route back to
the charging base thanks to its map memorizing and the smart back home function.