35
34
ENGLISH
ENGLISH
CAFELIZZIA 790 STEEL/SHINY/WHITE/BLACK
CAFELIZZIA 790 STEEL/SHINY/WHITE/BLACK
cleaning.
Do not use abrasive cleaners or scouring pads as they could cause damage to the product’s
surface.
Use a soft, dampened cloth to clean the outer part of the device.
Do not immerse the main body in water or other liquids.
Wash the water tank, drip tray and cup holder tray regularly.
After using the steam function, the tube must be cleaned with a cloth immediately after. Be
careful not to burn yourself! Allow steam to be released to avoid possible blockages inside
the tube.
If the steam tube is clogged, use a needle to unblock the conduct.
Remove the portafilter and empty all coffee residues inside it. Then, use water and a cloth to
clean it. Do not wash it in the dishwasher.
Clean all parts with water and dry thoroughly before storing it or using the device again.
Cleaning mineral deposits or descaling
Mineral deposits built up in the unit might affect the machine’s operating. It is important to
remove and clean them to keep the coffee machine operating efficiently. The quality of the
water being used and type of use will determine how often these deposits have to be cleaned.
It is recommended to carry out a cleaning cycle after each 1000 uses.
Fill the water tank with water and descaling product up to the MAX. level. Vinegar can also be
used.
Note: Water and descaling proportion is 4:1. Repeat this process just with water to remove any
rests.
5. TROUBLESHOOTING
Problem
Cause
Solution
Coffee does not come out
No water in tank.
Coffee grind is too fine.
There is too much coffee in
the filter.
The device is not turned on
or connected to the power
supply.
Coffee has been tamped/
compressed too much.
Add water.
Grind medium-ground coffee.
Fill filter with less coffee.
Connect the unit to a power
supply and turn it on.
Refill the filter basket with coffee,
do not tamp too much.
order to clean possible milk remaining inside the tube.
Hot water
Turn the steam knob to the water position. The steam tube will start dispensing hot water.
Turn the steam tube back to the 0 position to deactivate this function.
Memory function
Once the coffee machine has preheated and 1 espresso and 2 espresso light indicators remain
steady, hold down the 1 espresso button. The machine will start brewing coffee.
When you have obtained the desired amount of coffee, stop pressing the espresso button. The
machine will emit a sound, indicating it has saved the quantity.
The coffee machine brews coffee 60 seconds approx. by default, which is the maximum time
coffee can be brewed and saved.
Note: If the button is hold pressed too little time, the setting will not be saved.
If you want to prepare a larger espresso or 2 espressos, follow the above steps and use the 2
coffee button instead of the 1 coffee one.
Factory settings
If you want to restore factory settings, hold pressed the 1 coffee button and the steam button
for 3 seconds. The device will beep once indicating factory settings have been successfully
restored.
Device cooling process
After steam is emitted or coffee is brewed, the device’s temperature is likely to increase
significantly, which means that all of its components will become very hot as the device has
been operating at high pressure. Both of the light indicators, 1 and 2 coffees, will start blinking
quickly, indicating the device’s temperature has to be decreased.
To cool the device down:
Rotate the steam knob to the water position, the machine will start dispensing water for a few
seconds.
When the indicator lights start flashing slowly, turn the steam knob to the 0 position.
When the power light indicators remain steady on, the device is ready to use again.
Note: The coffee maker counts on an auto-off safety system that activates after 25 minutes
of non-operation.
4. CLEANING AND MAINTENANCE
Disconnect the device from the power supply and allow it to cool down completely before
