FAST&FURIOUS 5055 PRO
FAST&FURIOUS 5055 PRO
21
ENGLISH
20
1.
PARTS AND COMPONENTS
img
1.
(Page 26)
1.
Function indicator light
2.
LED display
3.
Temperature touch button
4.
Steam regulator
5.
Spray button
6.
Steam burst button
7.
Water inlet cover
8.
Spray nozzle
9.
Self-cleaning button
10. Soleplate
11. Sensor handle
12. Power cord
2. BEFORE USE
Warning: Some parts of the steam iron have been slightly greased and as a result, the device
may slightly smoke when switched on for the first time. After a short time, this will cease.
Take the product out of the box.
Remove any packaging materials, stickers or protective foil from the soleplate.
Clean the soleplate with a soft cloth.
3. OPERATION
Filling the water tank
Note: This appliance has been designed to be used with normal tap water. Do not use additives.
The addition of other liquids such as perfume, vinegar, starch, condensation water from tumble
dryers or from air conditioning systems or chemicals will damage the appliance.
1.
Unplug the iron from the power supply.
2.
Open the water inlet cover.
3.
Set the steam regulator to the desired position.
4.
Fill the water tank. Do not exceed the MAX. mark.
5.
Close the water inlet cover.
Note: To ensure optimum operating, mix tap water with distilled water. If tap water in your area
is very hard, mix tap water with distilled water.
Heating
Plug the device into a power supply.
Set the steam regulator to the “0” position.
The “Self-checking ” function will activate, and the light indicator will flash for 2 0 seconds
approx.
The device will automatically switch to the All textiles mode, and the corresponding light
indicator will light up, indicating
that the iron is heating up.
When the iron is ready to use, the light indicator will remain steady on.
Setting the temperature
Start by ironing the fabrics that require the lowest ironing temperature. Check the recommended
ironing temperature on the label on the garment.
Press the temperature button on the handle repeatedly to change the ironing temperature and
mode.
Press twice each time to switch mode.
The corresponding light indicator will turn on. When the iron is ready to use, the light indicator
will remain steady on.
Setting the steam
The steam regulator is used
to adjust the of steam produced when ironing. The recommended
position of the steam regulator for each temperature setting is as following:
img
. 2.
(Page 26)
Note: For better ironing results, iron the last strokes without steam to dry the garment.
Steam burst function
This function can be used to remove stubborn creases or to press in a sharp crease or pleat.
Set the temperature to "max".
Press the steam burst button repeatedly with intervals of at least 5 seconds.
Vertical steam
Vertical steam can be used
to remove creases from hanging clothes, curtains etc.
Set the temperature to "max".
Hang article of clothing on a clothes hanger.
Operate the iron in a vertical position at a distance of 10 cm/4 in and press the steam burst
button repeatedly with pauses of at least 5 seconds.
Note: If the Auto shut-off light indicator flashes while ironing in a vertical position, it means
that the handle is not properly gripped, and the iron will cool down. Grip the handle correctly in
such a way that the light indicator remains lit permanently.
Spray
Spray can be used
to remove stubborn creases.
When ironing, press the spray button and water will spray out of the spray nozzle onto the
garment.
ENGLISH
