98
Oil filter opening face down
1. Replace the oil filter and the o-ring on the cap. The opening side of oil filter must down to the
engine.
2. Smear engine oil around the o-ring of the cap.
3. Screw the cap by hand until the o-ring contacts the mounting surface (you will feel small
resistance).
4. Tighten the oil filter cap.
5. Reinstall the drain plug and tighten it. Torque it by 40N-m.
6. Pour about 3.5 liter specified engine oil into the dip stick hole.
7. Start the engine outside and well ventilated area. Allow it to idle for few minutes and check if
the oil pressure warning off.
8. Turn the engine off and wait for few minutes. Check the engine oil level. The engine oil level
should be at the “Maximum” position. Refer to “Liquid” section.
9.Inspectthevehicleifthereisanyoilleakage.
10. If the engine oil does not reach the “Maximum” position and there is not oil leakage, add the
engine oil until it reaches the “Maximum” position.
CAUTION
Using the oil not meeting the specification
can damage your vehicle.
Confirm to use the oil specified in the “Liquid”
section.
AIRCLEANER
The air cleaner element must be kept clean. If the air cleaner element is clogged with dust,
intake resistance will be increased, which will decrease in power output and increase in fuel
consumption. If ride this vehicle in dusty, wet, or muddy conditions, you must inspect the air
cleaner element much more frequently.
3
3
Summary of Contents for Kingcobra
