16
•
CEDIMA
® • Technical Documentation • All rights reserved according to ISO 16016 • Changes serving technical progress reserved •
Preparation and operation
CF•13.3 B / CF•13.3 B-L
ENGLISH
DANGER
Risk of injury!
Perform set-up works only with the joint cutter
(saw blade) at a standstill!
Make sure that the joint cutter will not start unintentionally or
might roll away!
4.1
Engine oil level check
Read the operating manual
for the engine!
The Oil Alert System automatically stops the engine
before the oil level drops below the safe minimum
level. However, to avoid the inconvenience of a
sudden shutdown, you should check the engine oil level
before each start.
Aligning frame with engine horizontally
Figure 4.1
1.
2.
DANGER
Risk of burns! Some engine parts will be very
hot in operation and cool down slowly after
stopping the engine!
With the rear engine oil dipstick, it is more likely to come into
contact with hot engine parts, therefore use the front engine
oil dipstick whenever possible!
Left, rear engine dipstick, filler lid
Figure 4.2
Loosening the holding screws at the front plate
Figure 4.3
5
For better front plate handling pull out the front trans-
port handle (section 7.1)!
Lifting the front plate out of the detent
Figure 4.4
4.0 Preparation and operation
Summary of Contents for CF 13.3 B
Page 55: ......
