Cutting with the CF•13.3 B / CF•13.3 B-L
35
•
CEDIMA
® • Technical Documentation • All rights reserved according to ISO 16016 • Changes serving technical progress reserved •
ENGLISH
5.2
Cutting operation
DANGER
The cutting operation must be done as wet
cuts!
As required, the cutting operation must be performed using
the wet cutting method in order to prevent the formation of
hazardous clouds of fine dust!
DANGER
Risk of injury due to insufficient coolant (lack
of water) and/or supply temperature too high
and thus resulting saw blade destruction!
Immediately stop the cutting work and the joint cutter if the
water cooling fails!
ATTENTION
Diamond tools (saw blades) designed for wet cutting
mode must never be operated without water! The tool's
life time will considerably be reduced and loss of seg-
ments is inevitable!
In case of dust or slurry formation at the saw blade, increase
the amount of water!
1. Perform visual checks of all joint cutter components,
2. Check the personal protective equipment,
3. Select the diamond saw blade that matches the material
to be cut from the
CEDIMA
® range and mount it,
4. Check the cordoning off of the operation area,
5. Provide suitable fuel and water supply,
6. Provide secure stand on even, firm, stable ground for
user and joint cutter,
7. Align the joint cutter to the cutting line,
8. Adjust the cutting depth indication,
9. Lift the diamond saw blade from the ground,
10. Start the engine,
11. Bring the engine and the diamond saw blade to full
speed,
12. Open the water shutoff valve (pressurised water or
water container) and thus control the required water
amount,
13. Slowly lower the diamond saw blade to the desired cut-
ting depth (see cutting depth indication). Hold tight the
joint cutter,
5.0 Cutting with the CEDIMA
®
joint cutter CF•13.3 B / CF•13.3 B-L
5.1
Requirements for cutting,
user location
DANGER
Danger of injury due to rotating diamond saw
blade!
The rotating saw blade can result in serious injury if not
handled carefully!
Only ever operate the joint cutter with completely mounted
saw blade and cutting shaft guard!
No person must be in the area behind the joint cutter (saw
blade) and in the are where diamond segments might be
ejected!
During operation, make sure that all third persons keep a
sufficient safe distance (approx. 10 m)!
If the safety clearance is not possible due to constructive
restrictions, the immediate danger area must be cordoned
off (e.g. with warning tape) and/or warning signs are to be
provided! Pay attention to objects and building parts to be
protected (remove or cover them).
ATTENTION
The joint cutter must be brought directly to
the work area while the saw blade is at a
standstill!
Ear defenders must be worm during cutting as
specified by the accident prevention regulations!
Suitable eye protection (protective goggles) is
strongly recommended!
Suitable safety shoes are recommended!
Wear suitable splash guard clothing!
ATTENTION
Depending on the operating conditions, other personal
protective equipment might be required!
The operator is standing behind the push handle of
the CF•13.3 B / CF•13.3 B-L (see section 4.3)!
Summary of Contents for CF 13.3 B
Page 55: ......
