Cutting with the CF•13.3 B / CF•13.3 B-L
36
•
CEDIMA
® • Technical Documentation • All rights reserved according to ISO 16016 • Changes serving technical progress reserved •
ENGLISH
Do not lower the blade guard by force to avoid dam-
age to the saw blade and the joint cutter!
A precise pre-cut of moderate depth facilitates the subse-
quent cuts and leads to a clean cutting line.
ATTENTION
Secure the cutting depth adjustment!
Tighten the cutting depth locking mechanism!
14. The cutting feed is done by pushing the joint cutter.
Start pushing the joint cutter slowly and continue to
push it evenly,
Adjust the feed speed to the engine power so that the
engine speed is slightly reduced!
15. Follow the cutting line (front visor) and continue to
control the cutting area visually, especially the water
supply, in order to intervene or, if necessary, to stop the
cutting operation at any time.
5.3
Finishing cutting operation
1. Stop the joint cutter (feed) and let the diamond saw
blade rotate freely in the cut,
2. Keep the joint cutter's position. Release the cutting
depth locking mechanism and lift the rotating the
diamond saw blade out of the cut. Then use the cutting
depth locking mechanism to secure the cutting shaft
(saw blade) position,
The joint cutter brakes automatically when lifting out
the cutting shaft!
3. Shortly rinse the diamond saw blade with the water
cooling system,
4. Stop the engine of the joint cutter,
5. Wait until the cutting shaft and the diamond saw blade
has come to a standstill,
6. If necessary, stop the compressed water supply and
disengage the external pressure water hose from the
joint cutter. Close the shut-off valve of the ater cooling or
drain the joint cutter (water container),
7. Prepare the joint cutter for the next step or for transport
(chapter 7), for this purpose dismount the diamond saw
blade,
8. Clean the joint cutter (the diamond saw blade),
9. Perform maintenance and care work according to chap-
ter 6.
5.4
Cutting operation in cold
environment, winter operation
T
Avoid damage due to frost!
In order to prevent freezing of the cooling system and damage
to the joint cutter, the water must be drained completely after
each operation and before longer breaks if the temperature
are below or around freezing point; else store the joint cutter
in frost-free conditions (section 4.9)!
Drain the shut down joint cutter (if necessary, blow out
the hoses with compressed air with 6 bar), place it in a
frost-free environment and/or cover it up!
If necessary, run the joint cutter with cooling or flushing
water plus antifreeze additives*!
*Obtained from car accessories.
Observe the operating manual of the engine!
5.5
Reasons to change the
diamond saw blade
• after complete wear of the diamond segments,
• in case of changes in the material to be cut,
• if the diamond saw blade runs out of true,
• if diamond segments are damaged or broken,
• if the saw blade is damaged or deformed due to tilting, ...
Replace the diamond saw blade as described in sec-
tion 4.6!
Summary of Contents for CF 13.3 B
Page 55: ......
