37
•
CEDIMA
® • Technical Documentation • All rights reserved according to ISO 16016 • Changes serving technical progress reserved •
Maintenance and care
CF•13.3 B / CF•13.3 B-L
ENGLISH
DANGER
Risk of injury! The joint cutter (engine) is to
be shut down for any maintenance and repair
work and to be secured against unexpected starting and
rolling away!
Stop the joint cutter engine according to the operating
manual of the engine and secure it against restart (see section
4.10.2)!
The basic safety instructions of this operating manual and the
operating manual of the engine must be observed!
The workplace for cleaning, maintenance, care and
any required repair works must be clean (dust-free)
and suitably equipped for the work!
• Place the joint cutter on a horizontal and stable ground
so that you have sufficient space for cleaning, mainte-
nance, care and repair!
• Clean the joint cutter before every maintenance or
repair!
ATTENTION
Do the maintenance works described in section 6.6 in the
specified cycles (table 6.6 "Maintenance intervals").
In doing so, also check the wear parts not specified in the
maintenance intervals and replace or adjust them if required!
Strictly adhere to maintenance and inspection intervals and
let the works be done by
CEDIMA
®
or personnel authorised by
CEDIMA
®
! This will extend the service life of your joint cutter!
ATTENTION
Use original spare parts!
Only original spare parts can ensure the operational safety of
the joint cutter!
6.1 Cleaning
Clean the joint cutter after each use and before every
maintenance or repair!
6.1.1 Cleaning agents
ATTENTION
Never use aggressive detergents!
Aggressive cleaning liquids (e.g. solvents) as well as cleaning
with liquids with a temperature above 30 °C is not permitted!
ATTENTION
Do not use high pressure or steam cleaning devices!
For reasons of safety and functionality, no water, detergent or
steam may enter the engine and the engine components (e.g.
air filter, fuel system), therefore do not use high pressure or
steam cleaners!
6.1.2 Notes about dry cleaning
• Remove dust and dirt with a slightly damp cloth!
• Use lint-free cleaning cloths!
• Remove tenacious deposits with a (not too hard) brush,
if required!
6.1.3 Notes about wet cleaning
• Before cleaning the machine with water or other clean-
ing agents cover or tape up all openings, housing, plug
connection (insulating tape) to protect them against the
ingress of moisture!
• Use a "soft" water jet and a brush (not too hard) to re-
move dirt and residue!
• Be especially careful at critical spots (e.g. switches, en-
gine, ...)!
The electric and especially the electronic components may not
come into contact with the water spray!
• Do not flush any bearings else there is a risk of running
dry!
• After cleaning, remove the covers/tapes completely!
6.0 Maintenance and care
Summary of Contents for CF 13.3 B
Page 55: ......
