ENGLISH
19
•
CEDIMA
® • Technical Documentation • All rights reserved acc. to ISO 16016 • Changes serving technical progress reserved •
Erection and operation
Joint Cutter CF-22 E.800
4.4
Adjusting and using the front pointer
DANGER
Risk of pinching or crushing when swivelling
the front visor!
Careful with hands and fingers!
Alignment of the pointer is carried out with the motor stopped
and with the diamond saw blade fitted.
Loosen locking pin and swivel front pointer down
Fig. 4.9
lock pin
Aligning the front pointer for right and left-hand cuts
Pull out the locking bolt and swivel down the front pointer.
Align laterally with a guide line or guide rail in direct
alignment with the diamond saw blade so that the tip of
the visor rod is directly aligned with the cutting line. To do
this, turn/move the visor rod accordingly if necessary.
Move the visor rod accordingly by loosening the screw.
Fig. 4.10
4.5
Connecting the water supply
The
CEDIMA
® joint cutter CF-22 E.800 is supplied with
water via a GEKA coupling.
The water shut-off valve located behind it allows you to
stop or reduce the supply of water.
Geka water coupling
with shut-off valve
Fig. 4.11
Only use water for cutting that is free of coarse impurities
to prevent blockages of the water supply.
ATTENTION!
Diamond tools designed for wet cutting mode must
never be operated without water! This also leads to an
inevitable loss of segments!
4.6
Electric connection
DANGER
Risk of injury due to electric short-circuit!
Never plug or unplug the power cable while the electric supply
is switched on or the saw blade drive motor (system under
electrical voltage) is running!
Lay the mains cable in such a way that there is no risk of
danger or damage and so that it cannot be pulled in or wound
up!
Do not expose the joint cutter to direct water jet and/or
extreme humidity! The joint cutter is splash-proof when
standing horizontally on its wheels!
All electrical connections
must be kept free from moisture!
ATTENTION
Observe the corresponding safety precautions!
Chapter 3, in particular section 3.2.5!
