ENGLISH
21
•
CEDIMA
® • Technical Documentation • All rights reserved acc. to ISO 16016 • Changes serving technical progress reserved •
Erection and operation
Joint Cutter CF-22 E.800
Start the engine using the star-delta reversing switch on the
switch box.
2. Turn the star-delta reversing switch right to the
Y
position until the saw blade begins to turn.
∆ Y 0 Y ∆
Star-delta reversing switch in Y position
Fig. 4.13
ATTENTION
Observe the rotational sense of saw blade.
The rotational sense of the saw blade must correspond to the
direction indicated by the arrow on the blade guard (Fig. 4.7)!
(the rotational sense of the ventilator wing on the motor must
correspond to the arrow on the ventilator cover)
3. If the direction of rotation of the saw blade is incorrect,
switch the star-delta reversing switch to
0
and allow the
motor to come to a standstill!
Then turn the reversing switch in the opposite direction
to the
Y
position (for the first start)! Once the rated
speed is reached, switch to position
∆
.
4. If the direction of rotation of the saw blade is correct, the
switch is switched to the
∆
position after the rated speed
has been reached.
ATTENTION
Do not operate the motor in the
Y
position!
∆ Y 0 Y ∆
Star-delta reversing switch in ∆ position
Fig. 4.14
4.7.2 Stopping the motor
1. Raise the diamond saw blade out of the cut so that it can
turn freely!
2 Turn the star-delta reversing switch to position
0
(Fig. 4.12)!
The engine and thus the diamond saw blade will come (spin)
to a stop!
4.8
Cutting depth 0 position
Before starting to cut, the cutting depth setting
must be set to 0 (depending on the diameter of the
saw blade).
Stopper
Fig. 4.15
Hand crank
Spindle
1. Mount the diamond saw blade.
Star-knob screw for
locking the spindle
Cutting depth
display
