Issue 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
14
TESTING/OPERATION CONTINUED…
7.04 When the call is complete, and the telephone is reset by way of the automatic
call timer or wink detection, the call will be terminated and the LED will go out.
If an automatic call disconnect was programmed, allow the conversation to
continue past the set time (1-9 minutes). Once the time limit expires, the phone
will automatically disconnect the call. A three-tone signal will be heard as the
call is disconnected. The time is not exact. If the automatic call disconnect
feature does not work properly, please repeat sections 3.02, 3.03, 3.04, 3.08, and
3.11 only. If trouble is still experienced, please refer to section 11.02.
7.05 If the phone was programmed to allow incoming calls, place a call into the
phone. When the phone rings, press the “CALL” button. The microphone
should activate approximately three seconds after the call is answered and a
normal speakerphone conversation should follow. If the phone was
programmed not to allow incoming calls, the microphone will not turn on. If
this does not work, please repeat sections 3.02, 3.03, 3.04, 3.08, and 3.11 only.
If trouble is still experienced, please refer to section 11.02.
7.06 Testing is now complete. If any trouble was encountered that has not been
remedied, please refer to section 11.02 of this manual, otherwise the phone is
ready for operation.
NOTE:
CEECO can not be responsible for the called party's response regarding
ADA features and compliance, and emergency response.
7.07 Carefully return the telephone assembly to the weatherproof housing. Secure it
in place using the four (4) security screws and security tool. If the telephone has
not yet been installed at its intended location, please refer to section 6.0, before
performing this step.
