Ref: 2015 Commode Range October 2015
Issue1
Form No: Cef 0035
User Instruction for the 2015
Mediatric/Bariatric & Super
Bariatric Commode range
2. Contents
Commode
User Instructions (this leaflet)
Batch label – This will be found on the product and will include the product code as well as a number. In the
event of needing to contact the manufacturer about this product always quote the Batch Number.
3. Assembly Instructions
Carefully unpack and examine the product to ensure it is complete.
Before use check for any signs of damage e.g. cracked weld, flaking of paint, bent tube. If any signs occur
please contact your supplier to exchange and refrain from using the product.
DO NOT ATTEMPT TO USE IF PRODUCT IS DAMAGED.
To
adjust the Commode height
1.
Remove the pin clip from the leg individually
2.
Select the height by positioning each extension leg individually, aligning the
holes in the extension leg and frame
3.
When the required height is selected re-fit the pin clip into the appropriate
hole ensuring the pin is fully engaged
4.
Repeat the above on the other three legs
5.
Ensuring all four pin clips are fully engaged and check that all four legs are
set to the same height
To adjust the removable back (DB versions only)
1.
Unscrew the handle wheels (clockwise) around half one full turn
2.
The detachable back should now slide freely in the locating brackets
3.
Once the desired position is reached re-tighten (anti-clockwise) the four
hand-wheels to lock the back in position
4.
As an added safety feature pin clips are inserted between the hanging
brackets to stop the back from sliding out of the brackets
ensure these pin
clips are always inserted when the product in in use
The back may have been located in an inverted position for transit. If so remove
the two safety pin clips located on the back between the hanging brackets,
slightly unscrew the hand wheels as above, fully withdraw the back from the
brackets. Then rotate the back to an upright position and slide the back into all
four brackets, insert the safety pin clips & repeat the adjustment process to
locate and secure the back in the correct position.
To remove detachable arms (models including, 222 only)
1.
Withdraw the retaining pin clips from both the front and rear of the arm
which is to be removed
2.
Lift the arm upwards away from the commode
3.
Reverse this process to replace the arm securely
