02PN8 HI-PE/CF --- Rev. F044GB60K10
8
Code
Meaning
Possible
values
Type
Notes
Display indication: When the value is under the alarm threshold, the indication is green,
when the value is above the alarm threshold, the indication is red.
IS
International
Security
Standard
see the
followin
g table
C,R
TI
Transmitter
inhibitor
NO,
YES
Deactivates the transmitter if the Metal Detector is inhibited.
The Metal Detector behaves as follows in the two different situations:
TI=NO the metal detector is immediately operational when the inhibition signal
is switched off
TI=YES when the inhibition signal is switched off, the Metal Detector resets; in
this case, it is necessary to wait a few moments (0.5 – 2 sec) before the
Metal Detector is operational (tr in the diagram below)
inhibition
signal
TX
alarm
relay
tr
inhibition
TX inactive
reset
normal
operation
0,5 - 2s
Fig. IV-1
Delay before the metal detector is operational with TI=ON: after deactivation of
the inhibition signal, it is necessary to wait for time tr before the detector
reactivates
ANALYSIS PROGRAMS AVAILABLE WITH THE COMMAND "IS"
PROGRAM IS
DISPLAY
MESSAGE*
SECURITY LEVEL / APPLICATION
SAMPLES
1
N I L . 1
Standard : NILECJ-STD-0601.00 Security Level 1
AM9
2
N I L . 2 B A
Standard : NILECJ-STD-0601.00 Security Level 2
Basic specifications
AM7
3
N I L . 3 B A
Standard : NILECJ-STD-0601.00 Security Level 3
Basic specifications
AM5
4
N I L . 2 A D
Standard : NILECJ-STD-0601.00 Security Level 2
Additional specifications
AM7; AN7
5
N I L . 3 A D
Standard : NILECJ-STD-0601.00 Security Level 3
Additional specifications
AM5; AN5
6
H I G H I M M
Level with high immunity to environmental
interference (corresponding approximately to level
NILECJ 2, with additional specifications).
-
* The display message also appears when not in programming if the
key is pressed.
;
;
;
;
;
;
;
;
;
;
;
;
;
;
;
;
;;
;;
;
;
;
;
;
;
;
The unit is programmed in the factory to ensure operation according to the IS standards for the passage width
listed in the "Hardware and software configuration sheet" included at the end of the manual. If, for any reason,
the passage width has been changed, this correspondence is not guaranteed.
