HI-PE multi-zone --- Rev.
FI 050 GB 60K10 v2_1
11
Positioning
Transit requirements
The Metal Detector will be positioned, according to the requirements dictated by the transit, in such a way as
to allow the maximum flow of people and observance of the rules for installation.
See notes on the following pages for correct positioning
.
Minimum distances - Electrical and mechanical compatibility
General Rules:
- avoid movement of significant metal masses less than 70 cm from the Metal Detector antenna;
- avoid the presence of electric lines and electrical devices less than 30 cm from the metal detector probe,
especially the receiver section (RX).
- move electrical/electronic devices (e.g. motors or switching power supplies) in general away from the
metal detector probe, especially the receiver section (RX): the distance depends on the type and power
of the device.
IMPORTANT
!
The distances mentioned are indicative only:
The amount of interference should be assessed at the time of installation (see paragraph “Installation
Check”).
----
…
*
no signal or one green asterisk: interference acceptable
!
Fixing the antenna to the ground
To fix the antenna to the ground
screw the expansion screws (
vf
)
into the floor through the holes
provided in the base flanges.
Carefully check the
perpendicularity and alignment of
the transmitter and receiver
sections, ensuring that they are
anchored at the right distance
vf
Fig. II-2a
+ 50 (2")
630 (24"
3
/4)
ø 6.5 (ø1/4")
UW= 720/760/820mm
Fig. II-2b - Diagram of holes for
fixing to ground
Stability
To operate properly the antenna should not be subject to shocks or movements. Follow the installation
instructions and ensure that the Metal Detector probe is stable and anchored firmly to the ground using screws
or silicone. Check the rigidity of the floor; in particular, avoid installation on:
•
Wood floors
•
"technical"-type floors, as these generally do not rest on surfaces which guarantee stability over their whole
area.
Holes
It is strictly forbidden to make holes in the Metal Detector antenna or to insert screws in positions, or of lengths,
not expressly indicated by CEIA. Damage due to such actions is not covered by the product warranty.
