Ceia HI-PE multi-zone Series, Installation, Use And Maintenance Manual

HI-PE multi-zone --- Rev. 

FI 050 GB 60K10 v2_1

34 

Parameters accessible from remote programming only 

Function code 

:   

C= command 
R= status request  
S= the command can only be accessed from the super-user level 

Code 

Meaning 

Possible value

Type  Notes 

CI 

Number of 
inward 
transits 
 

0-999999 

R 

This function displays the number of transits made through the gate, in the direction defined 
by parameter GD, since the last time the alarm counter was reset (command CR). 
 

During normal operation, the current value of this parameter can be seen on the display if the 

. or   

 key is pressed 

CO 

number of 
outward 
transits  
 

0-999999 

R 

This function displays the number of transits made through the gate, in the direction opposite 
to that defined by parameter GD, since the last time the alarm counter was reset (command 
CR). 
During normal operation, the current value of this parameter can be seen on the display if the 

. or   

 key is pressed 

RE 

Alarm reset   - 

C 

ATTENTION! 

The metal detector will operate under manual reset only during a programming 

session and with the reset mode set on "manual" (see the 

RM

 function). Outside of the 

programming session, the device will operate under automatic reset.   
If the 

RE

 command has not been authorised for the user environment, the mechanism will 

operate under automatic reset during a programming session at user level. 
 

RM 

Alarm reset 
mode 

M, A 

C/R 

M Mode

: corresponds to manual reset via command 

RE

. The alarm is kept in memory until 

the RE command is executed.  (N.B.: any reset button that might be connected to terminal 
PP1 will not have any effect)   
 

A Mode

: corresponds to automatic reset:: the alarm stops shortly after the transit through the 

transducer is completed. 

AA 

Indication of 
the size of 
the metal 
mass 
detected 

0-4 R 

Displays the size of the metal mass detected (during an alarm in manual reset mode, see 

RM

function). 5 different values can be adjusted, ranging from:   
    •  0 (no alarm) 

    •  1 (small mass)   
    •   

    •   

    •  4 (large mass).  

Status reading does not reset the Metal Detector alarm. 

HE 

HELP 

- 

R 

This selects a display of the meaning of the programming codes. The read-out will give the 
correspondence table (function – function code) 
The   *   character indicates that the command is enabled at user level (see the 

UP

command). 
 

PE 

Programmin
g end 

- 

C 

This command will be executed automatically if no commands are entered for a period of 2 
minutes. 
 

PT 

Parameter 
table 

- 

R 

Displays the values of the operating parameters. The serial number of the device appears at 
the top. 
The character    *   indicates that the command is enabled at user level (see command 

UP

). 

SC 

Self-
diagnosis 

R 

Displays the status of the Metal Detector. When operating properly, this message appears:
 

OK

System working perfectly  

If one of the device’s components is faulty, a message will be displayed (in descending order 
of priority). For  more details see the “Maintenance” section. 
 

N.B.: 

The SC command can only be executed in remote programming. The self-diagnosis 

device is permanently active, and any indication of malfunction is given automatically on the 
display.