5.2.2.1.3.2. UDP CLIENT & SERVER CONFIGURATION IN CASE OF SLAVE DEVICE
Set operating parameters of UDP server on the converter connected to SLAVE device eg. like on picture below. Set access to UDP
server on e.g. 2101 port. Then select
Automatically send serial data
in section
UDP Client Settings
, this automatically send
received data by the use UDP client service to the MASTER device connected to LAN / WAN through e.g. ADA-13021MG,
ADA-13040, ADA-13110, ADA14040, ADA-14040.
On lists
Send data to the following network services
are addresses of network devices and ports to which will be send data. In
field:
–
Description
- enter e.g. location of the converter and MASTER device,
–
Send To
- enter IP address of converter connected to MASTER device,
–
UDP Port
- enter the number of port on which is working UDP Server of converter connected to MASTER device
In the section
Send data under any of the following conditions
is recommended to set parameters like on picture bellow.
For saving the configuration of UDP client and server for SLAVE device, press
[Apply]
.
Fig.23. Example configuration of the UDP server&client on converter connected to SLAVE device
ATTENTION !
Default port of serial port service is 2101.
If on the local network is conflict with other network service using the same port, in the converter's port configuration
change number of port into another for the server and client service .
5.2.2.1.3.3. SERIAL PORT TRANSMISSION PARAMETERS CONFIGURATION
For proper operation of ADA-13021MG with device connected to his serial port (Current Loop), should be set the same transmission
parameters for both devices.
Select
Basic Serial Settings
and enter
Baud Rate
,
Data Bits
,
Parity
,
Stop Bits,
the same parameter like has device connected to
the serial port of the converter.
5.2.2.1.4. SERIAL BRIDGE PROFILE CONFIGURATION
Choosing the
Serial Bridge profile
enable direct communication between two devices connected to two ADA-13021MG converters
over the network as if they were connected with a serial cable. A properly configured ADA-13021MG will start automatically
communication with each other. Press [
Apply
] for save the configuration
21
ADA-13021MG
