10. SPECIFICATION
TECHNICAL DATA
Transmission Parameters
Interface
ETHERNET
Current Loop CLO
Connector
RJ45
Screw terminal, wire diameter max
2,5mm
2
.
Line length
LAN up to 150 m
Depend on baud rate up to few hundred
meters
Max. number of connected devices
Depend on addressing type setting in the
network
2 point-to-point or 15 in Current Loop
CLO network
Max. baud rate
10/100 Mbit/s
19,2 kbps (depend on length of Current
Loop CLO line)
Transmission line
4-pair twisted cable, UTP
4x2x0,5(24AWG), shield inside large
interferences (STP 4x2x0,5(24AWG)).
2-pair twisted cable, 24AWG, shield
inside large interferences
Standards
IEEE 802.3
0-20mA /12VDC, 0-20mA /24VDC
Transmission type
Asynchronism half duplex or full duplex,
Optical Signalization
•
PWR – green LED power supply,
•
RX - red LED data receiving from Current Loop CLO side,
•
TX - yellow LED data transmission through Current Loop CLO interface.
Electrical Parameters
Power requirements
10 - 24 – 30 V DC
Power Cable
Recommended length of power cable – up to 3m
Power
3W
Protection from reverse power polarization
YES
Galvanic Isolation
1kV= or 3kV= (between power circuit and ETHERNET signal line)
1kV= or 3kV= (between power circuit and Current Loop CLO signal line)
Optoisolation
~3kV= (between signal lines Current Loop and ETHERNET)
Electromagnetic compatibility
Resistance to disruptions according to the standard PN-EN 55024.
Emission of disruptions according to the standard PN-EN 55022.
Safety requiring
According to the PN-EN60950 norm.
Environment
Commercial and light industrial.
Environmental Parameters
Operating temperature
-30 ÷ 60°C
Humidity
5 ÷ 95% - non-condensing
Storage temperature
-40 ÷ 70°C
Casing
Dimensions
53mm x 90mm x 62mm
Material
PC/ABS
Degree of casing protection
IP40
Degree of terminal protection
IP20
Weight
0,10 kg
According to standards
DIN EN50022, DIN EN43880
Location during work
Free
Mounting method
On the rail compliant with DIN35 / TS35 standard.
26
ADA-13028L
