1
TX+
White-Orange
2
TX-
Orange
3
RX+
White-Green
4
Not used
Blue
5
Not used
White-Blue
6
RX-
Green
7
Not used
White-Brown
8
Not used
Brown
White-Green
TX+
1
Green
TX-
2
White-Orange
RX+
3
Blue
Not used
4
White-Blue
Not used
5
Orange
RX-
6
White-Brown
Not used
7
Brown
Not used
8
In the modular socket ETHERNET interface of converter, are implemented two LED's (Fig. 1):
–
Green ACT signaling state of sending or receiving data,
–
Orange LINK signaling active network connection.
ADA-13110 converter can function in the ETHERNET network as:
–
virtual serial bridge [RealPort],
–
TCP serial bridge,
–
UDP serial bridge.
Additional information about Ethernet connection will be describe in chapters below.
3.2.1. CONNECTING TO NETWORK ADAPTER OF PC
If there is not the switch or the HUB, it is possible to connect the ADA-13110 directly to a network adapter of PC using the cross-over
cable (Table 2). This connection can be used for converter configuration.
Fig 3. Direct connection to PC
3.2.2. CONNECTING FOR OPERATING IN REALPORT MODE
Figures 3 (above) and 4, 5 (below) show how correctly connect the ADA-13110 to LAN, WAN network or PC, for operating in virtual
serial port mode (RealPort).
For direct connection of the converter to PC network adapter, use the cross-over cable (see Table 2) and for connection by the use of
switch or HUB use the straight cable (see Table 1).
6
ADA-13110
PC with a network
adapter
Static IP address
ADA-13110
Static IP address
ETHERNET
Crossover cable
(Table 2)
