background image

9016939

7.5 ft PRE-LIT PE FRESH CUT FRASIER TREE

A
B

C
D

TREE - TOP

TREE - CENTER, STICKER 2

TREE - BOTTOM, STICKER 1

TREE STAND

1
1
1
1

PART

DESCRIPTION

QUANITY

E
F

G

LIGHT CONTROLLER

POWER ADAPTER

SPARE PARTS PACKET

1
1
1

PART

DESCRIPTION

QUANITY

Please check to make sure you have the following parts

Before You Begin

When using electrical products, basic precautions should always be 

followed, including the following:

•  Do not use seasonal products outdoors unless marked suitable for 

indoor and outdoor use. When products are used in outdoor 

applications, connect the product to a Ground Fault Circuit Interrupting 

(GFCI) outlet. If one is not provided, contact a qualified electrician for 

proper installation.

•  This seasonal product is not intended for permanent installation or use.

•  Do not mount or place the product near gas or electric heaters, 

fireplaces, candles, or other similar sources of heat.

•  Do not secure the wiring of the product with staples or nails, or place on 

sharp hooks or nails.

•  Do not let lamps rest on the supply cord or on any wire.

•  Unplug the product when leaving the house, when retiring for the night, 

or if left unattended.

•  This is an electric product-not a toy! To avoid risk of fire, burns, personal 

injury and electric shock it should not be played with or placed where 

small children can reach it.

•  Do not use this product for other than its intended use.

*  Do not hang ornaments or other objects from cord, wire, or light string.

•  Do not close doors or windows on the product or extensions cords as 

this may damage the wire insulation.

•  Do not cover the product with cloth, paper, or any material that is not a 

part of the product when in use.

•  This product is equipped with push-in type lamps. Do not twist lamps.

Read and follow all instructions that are on the product or provided with 

the product. 

SAVE THESE INSTRUCTIONS.

CAUTION: USE ONLY POWER ADAPTER THAT WAS PROVIDED 

WITH THIS PRODUCT. USING A DIFFERENT POWER ADAPTER 

WILL DAMAGE THE LIGHTS AND CAUSE FIRE, ELECTRICAL 

SHOCK HAZARD.

FCC NOTICES

:

WARNING: Changes or modifications to this unit not expressly approved 

by the party responsible for compliance could void the user’s authority to 

operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits 

for a Class B digital device, pursuant to Part 15 of the FCC Rules. These 

limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses 

and can radiate radio frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not 

occur in a particular installation. If this equipment does cause harmful 

interference to radio or television reception, which can be determined by 

turning the equipment off and on, the user is encouraged to try to correct 

the interference by one or more of the following measures:

•  Reorient or relocate the receiving antenna.

•  Increase the separation between the equipment and receiver.

•  Connect the equipment into an outlet on a circuit different from that to 

which the receiver is connected.

•  Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject 

to the following two conditions:

1. this device may not cause harmful interference, and

2. this device must accept any interference received, including interference 

that may cause undesired operation.

IMPORTANT SAFETY INSTRUCTIONS - READ AND FOLLOW ALL SAFETY INSTRUCTIONS.

Reviews: