1
1
CE CONFORMITY
•
Celectron
products comply with direc ve 2004/108/EC (EMC), as stated in EN 55103-1 and EN 55103-2 standards and with direc ve
2006/95/CE
(LVD), as stated in EN 60065 standard.
• Under the EM disturbance, the ra o of signal-noise will be changed above 10dB.
PACKAGING, SHIPPING AND COMPLAINT
• This unit package has been submi ed to ISTA 1A integrity tests. We suggest you control the unit condi ons immediately a er unpacking it.
• If any damage is found, immediately advise the dealer. Keep all unit packaging parts to allow inspec on.
•
Celectron
is not responsible for any damage that occurs during shipment.
• Products are sold “delivered ex warehouse” and shipment is at charge and risk of the buyer.
• Possible damages to unit should be immediately no
fi
ed to forwarder. Each complaint for package tampered with should be done within
eight
days from product receipt.
WARRANTY AND PRODUCTS RETURN
•
Celectron
products have opera ng warranty and comply their speci
fi
ca ons, as stated by manufacturer.
•
Celectron
warrants all materials, workmanship and proper opera on of this product for a period of two years from the original date of
purchase. If
any defects are found in the materials or workmanship or if the product fails to func on properly during the applicable warranty
period, the owner
should inform about these defects the dealer or the distributor, providing receipt or invoice of date of purchase and defect
detailed descrip on.
This warranty does not extend to damage resul ng from improper installa on, misuse, neglect or abuse.
Celectron Electronic
will verify damage on returned
units, and when the unit has been properly used and warranty is s ll valid, then the unit will be replaced or
repaired.
Celectron Electronic
is not responsible
for any "direct damage" or "indirect damage" caused by product defec veness.
INSTALLATION AND DISCLAIMER
•
Celectron
products have been expressly designed for audio applica on, with signals in audio range (20Hz to 20kHz).
Celectron
has no liability for
damages
caused in case of lack of maintenance, modi
fi
ca ons, improper use or improper installa on non-applying safety instruc ons.
• The installa on of these speakers is provided for indoors, in case of use outdoors be sure that the speakers are installed correctly in a
safe
loca on protected from wind, rain and humidity. To avoid performance deteriora on of mechanical, acous cs and electrical parts is not
advisable
to leave these speakers exposed outdoors for a long period of me, so we suggest a temporary installa on for the limited sound
events.
• The installa on of these speakers is provided for
fl
oor or by means of speci
fi
c stands able to support their weight. Therefore avoid installa on
on unstable elements such as: furniture, chairs and vibrant surfaces as stages or other speakers without appropriate
fi
x point speci
fi
cally designed
to avoid speaker movement. Then avoid the use of inadequate supports, we suggest to use
CELECTRON
stands and accessories only.
• In case of the speakers are provided of rigging points: DO NOT SUSPEND THE SPEAKERS FROM THE HANDLES, use exclusively these rigging points.
Consult professional rigger or structural engineers prior to suspending loudspeakers from a structure not intended for that use. Always know
the
working load limit of the structure suppor ng the loudspeakers. Always make sure that the rigging hardware minimum ra ng is at least
fi
ve
mes
the actual load, speakers and rigging hardware.
• In case of suspended installa ons of ac ve loudspeakers where is not possible to turn on and o
ff
the speakers from their appropriate
switches,
we recommend to install switches on the mains lines, for this purpose consult an expert electrician for the exact dimension of wiring.
• Locate the speakers as far away as possible from radio or television receivers or other sensi ve equipment. These speakers have a strong
magne c
fi
e
ld which can induce hum and noise into unshielded devices that are located nearby with consequent deteriora on of recep on of
image and sound.
•
Celectron Electronic
reserves the right to change these speci
fi
ca ons at any me without no ce.
•
Celectron Electronic
declines any liability for damages to objects or persons caused by lacks of maintenance, improper use, installa on not
performed
with safety precau ons and at the state of the art.
POWER SUPPLY AND MAINTENANCE
• Clean only with dry cloth.
• Check periodically that the slots for its proper ven la on and hea ng dissipa on are not obstructed by dust, remove the dust using a dry brush
or a compressed air gun.
• The ampli
fi
ed loudspeakers of
Celectron
have been designed with CLASS I construc on and must be connected always to a mains socket outlet
with
a protec ve earth connec on (the third grounding prong).
• Before connec ng the product to the mains outlet make certain that the mains line voltage matches that shown on the rear of the product, a
tolerance of up to ±10% is acceptable.
• Inside the ampli
fi
ed loudspeakers are present special safety devices such as:
9
Transformer and ampli
fi
er over-hea ng protec on.
9
Protec on against excessive power applied at each speaker.
•
THE REPLACEMENT OF FUSES INSIDE THE APPARATUS MUST BE MADE ONLY BY QUALIFIED PERSONNEL.
•
CHECK THE CONDITION OF THE PROTECTION FUSE, ACCESSIBLE OUTWARD, ONLY WITH THE APPARATUS SWITCHED OFF AND DISCONNECTED
FROM THE MAINS LINE OUTLET.
•
REPLACE THE PROTECTION FUSE ONLY WITH SAME TYPE AS SHOWN ON THE PRODUCT.
•
IF AFTER THE SUBSTITUTION, THE FUSE INTERRUPTS AGAIN THE APPARATUS WORKING, DO NOT TRY AGAIN THEN CONTACT THE
CELECTRON
SERVICE CENTRE.
