ENGLISH
I
7
ASSEMBLY
WHAT’S IN THE BOX
• Telescope tube
• Altazimuth mount and tripod
• H20mm (20x) – 1 25”
• SR4mm (100x) – 1 25”
• 3x Barlow Lens
SETTING UP THE TRIPOD
1 . Remove the tripod from the box (Figure 2-1) Stand the tripod upright and separate the tripod legs Then, push down
slightly on the tripod leg brace (Figure 2-2) Note: The very top of the tripod is called the altazimuth mount
2 . Next, install the tripod accessory tray (Figure 2-3) by placing the threaded post on the bottom of the tray over the hole
in the center of the leg support bracket (Figure 2-4) Turn the entire accessory tray clockwise to screw the tray in place
Be careful not to over tighten
3 . Extend the legs to the desired height Unlock the tripod leg lock knobs at the bottom of each leg (Figure 2-5) by turning
them counterclockwise and pull the legs out Then lock the knobs securely A fully extended tripod looks similar to the
image in Figure 2-6
Fig. 2-4
Fig. 2-5
Fig. 2-6
Fig. 2-2
Fig. 2-1
Fig. 2-3
NOTE:
The tripod will be the most rigid and stable at lower height settings.
• Erect image diagonal – 1 25”
• Finderscope: 5x24
• Accessory tray
• TheSkyX – First Light Edition DVD-ROM
Summary of Contents for 80AZS
Page 2: ......
Page 4: ...4 I ENGLISH ...
