40’ x 80’ Premiere I Series High Peak Pole Tent
www.GetTent.com / www.CelinaTent.com
PG.6
© 2013 Celina Tent Inc.
Preliminary set-up
1. Layout all of the staking hardware around the tent (minimum staking):
a. 3 stakes go to each corner location (place two 90° apart and one at 45°).
b. 1 stake goes to the remaining grommet locations.
c. 2 stakes go to each lace line location.
2. Place the stakes approximately 5’ from the grommet locations. Drive all of the stakes into the ground vertically
until approximately 6” of the stake is left exposed.
3. If using ratchets:
a. Distribute 1 ratchet buckle with loop strap (A) and 1 loop strap (B) for every stake
(disregard if installing a rope tent).
b. Attach the ratchet buckle with loop strap (A) to the stakes: turn the 6” loop at the end of the ratchet
buckle with loop strap (A) inside out and pull the strap through the loop to create a noose and pull tight
over the stake.
4. Place 1 pole to each grommet location.
5. Roll out drop cloth to protect the tent from dirt and abrasions.
Set Up Instructions
1. Unroll and unfold the tent top pieces on the drop cloth. The tent needs to be laid out in the sequence of:
40’x20’ lace end, 40’x20’ midsection (x 2), 40’x20’ grommet end. (The midsection has a lace and grommet side;
each seam requires one lace line and one grommet line for fastening.) Do not walk or stand on the tent fabric.
2. Lace the tent together:
a. Line up the two larger center pole grommets in the middle of each tent section (the lace end will
always be on the bottom) so that they overlap.
b. Starting in the middle and working toward the edge pull the first lace up through the first small
grommet. Pull the second lace up through the second grommet, then through the loop of the first lace.
c. While lacing the tent, be sure to connect the rain flap to the rope covering the lace line. This
eliminates the need to crawl on the tent after it has been laced.
d. Continue in this fashion until the third grommet from the edge of the tent is reached. The third lace
should be twice as long as the other loops (this is referred to as a double loop).
e. Pull the final two lines through the grommets and loop the second lace from the tent perimeter into
the first lace (the lace is now going towards the direction of the double loop). Pull the third lace (double
loop) through the second loop. The third lace (double loop) should now be strung through 2 loops (the
second loop and the fourth loop).
f. Tie off just past the third grommet; this secures the entire lace line.
g. Hook the twisted snap hook to the “O” ring to connect the tents together.
h. Connect the hook & loop located on the valance section at the end of each
lace line.
i. Repeat this method to secure all other lace lines.
SAFETY
MAINTENANCE
INS
TALLA
TION
CONT
AC
TS
INSTALLATION INSTRUCTIONS
