40’ x 80’ Premiere I Series High Peak Pole Tent
www.GetTent.com / www.CelinaTent.com
PG.9
© 2013 Celina Tent Inc.
Striking Instructions
1. Loosen the ratchet buckle assemblies and remove all side poles leaving only the corner poles.
2. Loosen and angle the center poles to relieve tension.
3. Roll out the drop cloth underneath the tent top.
4. Remove the center poles.
5. Loosen corner ratchets or ropes and remove corner poles.
6. Disconnect all of the ratchet buckles or ropes from the tent top.
7. Unlace the tent top:
a. Separate the valance hook & loop and unhook the twisted snap hook from the “O” ring that connects
the tents together. Unclip the rain flap until the lace line tie-off is accessed.
b. Untie knot and unlace the tent top section while disconnecting the rain flap.
8. Fold and roll the tent top pieces as tight as possible. Remember not to stand or walk on the tent top fabric.
9. Bagging (always use a drop cloth to protect the tent top from dirt and abrasions while bagging):
a. For Wrap-Around Tent Bag:
i.Lay the bag next to the tent top with the side-release buckles facing down. Roll the tent top
onto the center of the bag.
ii. Connect the two short male and female side-release buckles; pull tight.
iii. Connect the remaining side-release buckle and pull tight.
b. For Round-Bottom Bag:
i. Place the folded tent top into the upright vertical position.
ii. Pull the round bottom tent bag over the upright tent top.
iii. Turn the tent top and bag over, pull the draw string tight and tie off.
10. Fold and roll up the drop cloth.
INSTALLATION INSTRUCTIONS
SAFETY
MAINTENANCE
INS
TALLA
TION
CONT
AC
TS
