Erecting Procedure
7
www.HGPTS.com
1. Layout all the fittings and poles. Set the 8 way crown (F048WCHT) so the
four blue posts (that do not touch the ground) are pointed towards the corners.
ERECTING PROCEDURE
2. Slide the ends of the hip swage pole (Blue/HT2GST56S) onto the hip
rafter pole (Green/HT2GST80). Slide the ends of the rafter swage (Yel
-
low/HT2GST20S) onto the remaining hip rafter poles (Green/HT2GST80).
Slide the ends of the hip swage poles onto the corner posts on the 8 way
crown. Lining up the holes until the push pins engage.
3. Take the combined hip rafter poles (Green/HT2GST80)
and slide onto
the remaining post slots on the 8 way crown (F048WCHT). Lining up the
holes until the push pins engage.
4. Locate all four corner (F01CORHT) fittings and slide the hip rafter
poles
(Green/HT2GST80) on, lining up holes until push pins engage.