20’ x 30’ Master Series High Peak Frame Tent
www.GetTent.com / www.CelinaTent.com
PG.10
© 2013 Celina Tent Inc.
15. Step on the master series base plate to free both hands and lift one side of the tent frame. Do not lift one
corner at a time; lift the entire side of the tent. Insert corner fittings into the top of the leg, securing with a pin.
Insert all pins from the outside in; this keeps the protruding section of the pin from puncturing the tent fabric.
Make sure the staking hole on the base plate is on the outside of the tent.
SAFETY
MAINTENANCE
INS
TALLA
TION
CONT
AC
TS
INSTALLATION INSTRUCTIONS
12. Fasten the master series loop strap (D) to each corner and each point where valance curves meet by pulling
the strap through the two metal rings on the tent top, then through the end loop and tightening.
13. Attach the master series base plates to the legs (7’8” black) by sliding the leg tubing over the longer protru
-
sions on the master series base plates, securing with a pin.
16. Connect the O-ring of the master series ratchet buckle (C) to the base plate hook mounted on the small tub
-
ing of the base plate. Feed the master series loop strap (D) attached to the tent top through the reel bars slot of
the ratchet (ratchet buckle needs to have handle facing upward at all times) and pull the strap back towards the
tent approximately 1 ½ feet. Hold the strap at this point with one hand and begin to crank the ratchet handle
back and forth.
11. The 4’9” peak extension pole is now ready to be set. Insert the pole pin through the ring assembly in the tent
top. Be sure not to pinch or puncture the tent top fabric. Place the bottom of the center pole through the crown
adapter. Lining up the center hole on the pole with the hole on the adapter, secure the center pole to the crown
adapter with a bolt and nut. Repeat with the other peak extension pole.
14. In windy conditions, locate the downwind side of the tent to lift first; this keeps the wind from catching the tent.
