www.cellarcool.com | Page 37
WM & FD Twin
INSTALLING THE WALL MOUNT KIT
DRAIN PAN
1.
If removed, reinstall the top panel of the
unit housing.
2.
Align the front grille with the four (4)
ball studs on the housing. Push the
front grille onto the ball studs until it
snaps into place.
3.
Using a Phillips-head screwdriver, fasten
the bottom two (2) screws to fasten the
grille to the unit.
INSTALLING THE DUCTED PLENUM
1.
If removed, reinstall the top panel of the
unit housing.
2.
Align duct plenum with the four (4)
ball studs on the housing. Push the
duct plenum onto the ball studs until it
snaps into place.
3.
Using a Phillips-head screwdriver, fasten
the bottom two (2) screws to fasten the
plenum to the unit.
4.
Connect the supply and return duct
work to the unit.
5.
Using duct tape or foil tape, seal the
seam between the plenum and unit.
6.
Insulate all exposed metal on the unit to
prevent surface condensation.
NOTE:
Max ducting length is 25 feet per evaporator unit.
DRAIN PAN
