CellarCool Ultimate 3300, Owner'S Manual

www .cellarcool .com | Page 13

Ultimate Series

SINGLE-PIECE MOUNTING BRACKET

This sturdy bracket is used to frame the installation location 

and secures the unit to the wall studs . The bracket has been 

designed to hold the unit at a two-degree (2°) angle . This helps 

project air into the space and aids in condensation drainage .

Applying Insulation Tape 

Locate the six-foot piece of black foam tape included with the 

unit . Align one end of the foam tape with the upper left corner 

of the rear side of the mounting bracket . Stretch the tape across 

the rear of the bracket and cut the tape at the opposite edge . 

Peel off the white paper backing and attach the cut piece of 

foam tape to the top rear side of the mounting bracket . Follow 

the same procedure to place a piece of tape on the bottom edge 

of the mounting bracket . Place the remaining piece of foam tape 

on one side of the mounting bracket (spanning the distance 

between the pieces of tape on the top and bottom edges of the 

mounting bracket), then cut, remove paper backing, and secure . 

Do the same with on the opposite side of the bracket . Discard 

any excess . The foam tape will create a tight seal between the 

bracket and the wall . 

If you are installing through an exterior wall, please review the 

next page for specific instructions on exterior grill installation.

Mounting Bracket Installation 

Select your desired bracket mounting location (see diagram below) . This location determines the depth of the installation . For 

example, position #1 keeps most of the unit out of the cellar while position #4 sets the back of the unit near flush with the 

exterior wall . Slide bracket onto unit . Ensure that the TOP label on the bracket and the unit mounting flanges are towards the 

back . Use the four supplied 1/2” self-tapping screws to fasten the bracket to the unit . It is imperative that you use self-tapping 

screws no longer than 1/2” in length . 

1

2

3

4

#1  7.5–9.5” In Cellar

#2  11.5–13.5” In Cellar

#3  15.5–17.5” In Cellar

#4  19.5–21.5” In Cellar

5” inch thick wall  

(wall thickness may vary)

Mounting Bracket

Wine Cellar

Exhaust Area