Interface Wiring Diagram
(Oriented the same as the Watchman install)
❶
Wire
main power
from the transformer to the power connector on the
circuit board.
❷
Connect gate trigger wires from the
Normally Open
(NO)
and
Common
(C)
to the free-exit or exit terminals on the gate operator.
❸
Connect the gate status wires on the 6-pin connector on the main relay
and input plug to the magnetic switch or a
Dry Contact
, Normally Closed (NC)
relay on the gate operator.
❹
If using an optional 26-bit reader (ex., keypad, card reader, RFID, or
clicker), wire the device to the
Wiegand connection
on the interface circuit
board.
❺
Use
Camera Guide
if adding optional external camera.
❻
Test/activate using the test credentials on the
Activation & Test Process
document.
6-Wire Installation Instructions
Important Item
WXL
18 gauge stranded - up to 25 ft
16 gauge stranded - up to 50 ft
12 gauge stranded - up to 60 ft
Recommended Wire Guide
WATCHMAN
❶
❷
❹
❸
