5
Installation and Connection
INSTALLTION
1. Removing the dome cover
Determine where to install and use a wrench to remove the dome cover.
(From the next step, it is assumed that the power and network connectors are pre-installed.)
2. Network connection
Connect a RJ 45 jack to the ETHERNET connector of the Power / ETHERNET cable.
(Refer to PoE IEEE802.3af If you use PoE.)
3. Power connection
Connect a DC 12V 1A adaptor jack to the power connector of the Power / ETHERNET cable to
the. (The power connection is not necessary if you use PoE.)
4. Mounting
Mount the CamPilot MR330 on the installation point.
Use the fixing holes on the bottom plate.
5. Assigning an IP address
Assign an IP address. (Refer to the “Network Setting” at p.7~8.)
6. Adjusting the camera module
Adjust the direction of the camera module monitoring the video.
(Lens adjustment is not available.)
7. Replacing the dome cover
Replace the dome cover with the wrench.
▶ Fixing holes (bottom)
6
Internet
or
Intranet
Installation and Connection
REF
Monitoring PC Requirements
Item
Specification
Monitoring
PC
Processor
Pentium Core2 Duo or more
RAM
2GB or more
Graphic Card
512MB or more
OS
Windows 2003 / XP / Vista / 7
Monitor Resolution
1024 X 768 pixels or more
Network
10/100 Base-T LAN
CamPilot MR330
····
····
····
1
2
N
Power
Power
Power
HUB
General Connection
Monitoring PC
Monitoring PC
Local Network
Public Network
LAN (UTP) Cable
LAN (UTP) Cable
LAN Cable
Router
7
Network Setting
Setting an IP address of a CamPilot MR330
TIP
If a monitoring PC is on 192.168.1.xxx network area, the connection is available without
any change on CamPilot MR330.
The initial IP address on CamPilot MR330 is 192.168.1.2
.
In case of the direct connection, the monitoring PC (Note Book) should be changed into
192.168.1.xxx
When changing the network setting, use ENCP program.
1. Download ENCP (Easy Network Configuration Program)
• Please, refer to the link as below
http://cellinx.co.kr/files/board.3/5_NVS4.1%20(2011.04.06%201121).zip
• After unzipping the downloaded file and executing “Setup.exe”, you can run ENCP.
(Windows start button / All Programs / NVS 4.1)
2. Assigning an IP address on CamPilot MR330
• Click the button “
Scan
”, select an CamPilot MR330
• Input the
IP address, Subnet Mask, Gateway
and
DNS Server IP address
, click the button
“
Apply
”
• If you don’t have a proper IP address, ask the network administrator or refer to User Manual.
▶
▶
▶
▶
Click for Scanning
▶
▶
▶
▶
Click
for Applying
8
Network Setting
3. Accessing to CamPilot MR330 with a web browser
Open a web browser on a monitoring PC and enter the IP address assigned to a CamPilot
MR330 as following
Example>
http://192.168.1.2
• The page as below shows up after the connection is completed.
ID / Password :
root / pass
(Initial Value)
Monitoring
button :
moves to Monitoring Page
Guest Login :
connects by “guest” account
(The guest has no setting permission)
< The Initial Page >
< Monitoring >
All manuals and user guides at all-guides.com
