CelloTrack T Installation Guide
CelloTrack T Installation Guide
Page 11 of 20
Copyright © 2014 by Pointer Telocation, Ltd.
3
Installation Instructions
3.1
Installation Overview
------------------------------------------------------------------------------------------------
NOTE:
Refer to the relevant sections in the
Cello Family Installation Guide
for pre-
installation, wiring and post-installation steps and information.
------------------------------------------------------------------------------------------------
Perform the following steps when installing CelloTrack T devices:
1.
Verify that you have all necessary parts for your installation.
2.
Setup the CelloTrack (see Initial Setup for the CelloTrack and Initial Setup for the
CelloTrack Power ).
3.
Enable the cradle tamper switch if required (see Enable Cradle Tamper Switch).
4.
Find a suitable location to mount the device.
5.
Attach the CelloTrack cradle using the screws provided or double-sided adhesive tape
(see Mounting the CelloTrack Device and Mounting with the Magnetic Cradle).
6.
Snap the CelloTrack device into the cradle.
7.
(Optional) Secure the device to the cradle using zip ties (2 per side).
8.
For the CelloTrack Power:
i.
Run cable to power source and any PTO.
ii.
Wire accordingly.
9.
Switch on the device, if not already on (see CelloTrack Activation and Deactivation).
10.
Complete any required paperwork.
3.2
Tools and Equipment Required
Many of the following tools will assist your installation:
Power/Data Cable (supplied)
5 AMP Fuses (supplied)
In-Line Fuse Holder
Voltmeter or Testlight
Cordless Drill
Drill Bit Set
Screwdriver Set
Socket Set
Self-Tapping Screws
Electrical Tape
Wire Ties / Zip Ties
Wire Stripper
Butt Connectors (R,B,Y)
Crimping Tool
Cutting Tool
