Celme GPE 250, Installation Manual

11

 SAFETY MEASURES AND TRAINING THE FINAL USER 

 
THE  SKILLED  PERSONNEL  IN  CHARGE  OF  THE  INSTALLATION  AND ELECTRIC  
CONNECTIONS  IS RESPONSIBLE OF THE  TRAINING  OF  THE FINAL USER, WHICH MUST ALSO 
BE INFORMED ON THE SAFETY  MEASURES  TO COMPLY WITH.  
THIS INSTRUCTION MANUAL COMES WITH EACH EQUIPMENT. 

4)  USE OF THE EQUIPMENT 

4.1  CONTROLS 

 
THE CONTROLS AND PILOT LIGHT ARE SET ON THE RIGHT SIDE OF THE BASE WHEN THE 
MACHINE IS PLACED IN FRONT OF THE OPERATOR. (Fig.2) 
 
1.  BUTTON FOR STARTING AND STOP THE EQUIPMENT 
2.  KNOB FOR ADJUSTING SLICE THICKNESS  
3. LUBRICATOR 
 

4.2  SETTING THE FOOD ON THE SLICER SADDLE 

1.  SET THE FOOD ON THE SADDLE WHEN THE THICKNESS ADJUSTING KNOBIS SET TO ZERO 

AND WITH MOTOR OFF TO AVOID DAMAGING THE EQUIPMENT. 

2.  SET THE FOOD ON THE SADDLE AND BLOCK IT WITH THE FOOD-PRESS. 
3.  SET A HAND ON THE FOOD-PRESS AND START THE CUTTING. 
4.  WHEN THE FOOD IS FULLY SLICED USE THE FRONT PART OF THE FOOD-PRESS TO KEEP 

THE FOOD AGAINST THE BLADE. 

5.  WHEN THE CUTTING IS OVER, PUT OFF THE MOTOR AND STOP THE SLICE THICKNESS ON 

ZERO POSITION, THEN REMOVE THE FOOD FROM THE SADDLE. (Fig.3-4) 

5)  CLEANING AND MAINTENANCE OPERATIONS 

 GENERALITIES AND PRODUCTS FOR CLEANING 

 
BEFORE CARRYING OUT ANY CLEANING OR MAINTENANCE OPERATIONS, CHECK TO MAKE 
SURE THAT THE MAINS SWITCH BE OFF AND THE SUPPLY PLUG DISCONNECTED FROM THE 
MAINS. 
ACCURATELY CLEAN THE EQUIPMENT EVERY DAY FOR A CORRECT OPERATION AND LIFE OF 
THE EQUIPMENT. 
DESPITE THE SEVERAL SAFETIES, TAKE GREAT CARE TO AVOID CUTTING RISKS WHEN USING 
THE BLADE. 
CLEAN THE EQUIPMENT WITH THE USUAL NEUTRAL DETERGENTS WHICH MUST NOT CONTAIN 
SODA OR ALCOOL. WHEN CLEANING REMOVED ELEMENTS, DO NOT USE A  DISH-WASHER 
FOR NOT DAMAGING ANODIZED PARTS. 
 

 REMOVAL OF THE BLADE-COVER 

 
1.  LOOSEN THE KNOB OPPOSITE TO THE BLADE 
2. PUSH THE KNOB TOWARDS THE BLADE AND RELEASE THE BLADE- COVER FROM ITS 

HOUSING. 

3.  REMOVE THE BLADE-COVER FROM THE SLICER AND CLEAN IT WITH A WATER JET. (Fig.5-6) 
 

 CLEANING THE BLADE AND RING 

 
CLEANING  THE BLADE AND RING IS A DANGEROUS OPERATION, HENCE, TAKE GREAT CARE 
TO PREVENT ANY POSSIBILITY OF CUTTING. 
FOR THEIR CLEANING NEVER USE A WATER JET, BUT USE A DAMP CLOTH AND DETERGENTS, 
THEN RINSE AND DRY WITH A CLOTH. 
FOR THE CLEANING, USE NON-TOXIC PRODUCTS WHICH GUARANTEE THE PERFECT HYGIENE. 
CLEAN CAREFULLY THE BLADE EDGE AND THE INSIDE OF THE RING. 
 
2.  USE A DAMP CLOTH TO CLEAN THE OPENING BETWEEN THE BLADE  AND RING. 
3.  ROTATE MANUALLY THE BLADE AND CLEAN USING THE DAMP CLOTH. (Fig.7-8)