18
1. USE A DAMP CLOTH TO CLEAN THE OPENING BETWEEN THE BLADE AND RING.
2. ROTATE MANUALLY THE BLADE AND CLEAN USING THE DAMP CLOTH.
5.6 REMOVING AND CLEANING THE SHARPENER HEAD
LOOSEN THE KNOB AS SHOWN IN FIGURE, LIFT THE HEAD AND THE SHARPENER UNIT, AND
REMOVE THESE UNITS BY LIFTING AND TURNING BY 180°.( Picture 1)
TURN OFF THE HANDLE “B” TO TAKE OFF THE SLICE PROTECTION. (Picture 2)
Picture 1 Picture 2
5.7 REASSEMBLING THE MACHINE
FOR THE MACHINE REASSEMBLY, REVERSE ALL THE ABOVE MENTIONED OPERATIONS.
6) SHARPENING AND LUBRICATION
6.1 SHARPENING
THIS A VERY IMPORTANT OPERATION TO CARRY OUT EVERY TIME THE CUTTING IS NOT
CLEAN, OR WHEN THE BLADE DRAGS THE SLICE.
THE USE AND THE TYPE OF PRODUCTS THAT HAVE BEEN SLICED DETERMINE THE
PERIODICITY OF THIS OPERATION.
BEFORE SHARPENING THE BLADE, CLEAN THE MACHINE AND DEGREASE THE BLADE
ACCURATELY.
BLADE
RING
A
B
Summary of Contents for VPR 300
