Smart Control functions
The Smart Control panel reveals additional buttons to allow the following functions
Set the Time of day
Thermostatic temperature adjustment from 16 to 30°C
Set 7-day timer with up to 3 programmable periods per day
Turn Adaptive Control On or Off
Turn Off and clear timer settings
Setting the Time
1.
Press the SYNC button, which will start the day cursor to blink. Using the time arrow
buttons set to the current day e.g. Monday – 1, Tuesday – 2, Wednesday – 3 etc. Press
SELECT to confirm the required day.
2.
The hour setting will now be blinking, adjust using the time arrow buttons to the desired
hour and confirm using the SELECT button.
3.
The minute setting will now be blinking, adjust using the time arrow buttons to the
desired minutes and confirm using the SELECT button.
Adjusting the desired temperature
Whilst the fire is switched on, use the Temperature Arrows to set the desired room
temperature. A confirmation beep will be heard from the fire. If the room is already warmer
than the temperature set then the heater will switch off until the thermostatic sensor
detects a fall in temperature.
Setting the Timer function
The timer function allows up to 3 timers to be programmed for use over a 7 day period.
1. Press the TIMER button to display the first timer, and then press the SELECT button to
adjust Timer 1 programme.
Set Time ON
2.
The hour setting will now be blinking, adjust using the time arrow buttons to the desired
hour to switch on the fire and confirm using the SELECT button.
3.
The minute setting will now be blinking, adjust using the time arrow buttons to the desired
minutes to switch on the fire and confirm using the SELECT button.
4.
The day cursor will now be blinking, use the time arrow buttons to highlight the required
day and press SET, additional days can be added using the time arrows and SET buttons.
If you add a day in error, select the day and press the CANCEL button to unselect. Only
when you have set all the days you require for the timer press SELECT to
confirm.
Set Time OFF (this must be at least 30 minutes after the ON time)
5.
The hour setting will now be blinking, adjust using the time arrow buttons to the desired
hour to switch off the fire and confirm using the SELECT button.
6.
The minute setting will now be blinking, adjust using the time arrow buttons to the
desired minutes to switch off the fire and confirm using the SELECT button.
7.
A confirmation beep will be heard from the fire to confirm Timer 1 programme is now set.
Page 9
