16
Ver. 05-2015
Calibro a riposo
Piano flangia
0 Sonar
A
gauge at rest
Flange plane
ENGLISH
Use and maintenance manual
6.5.2 Diameter gauge
E
Display the SETUP menu
1. Press
to view the diameter gauge
CALIBRATION function.
m
2. Place the gauge rod on the spindle shell as shown
in the figure and press
3. Turn the gauge downward positioning the gauge rod
in contact with the spindle sleeve as shown in the
figure
and press
CALIBRATION COMPLETE
▪
Return the gauge to rest position.
▪
The wheel balancer is ready for operation.
In case of errors or malfunctions, the indication of the
same step [P.1] or [P2], always reappears on the display.
Move the gauge back into rest position and repeat the
calibration operation as described above; if the error
persists, contact Technical Service.
If erroneously accessing the diameter gauge calibration
function, press
to cancel it.
6.5.3 Width sonar (option)
Display the SETUP menu:
1. Press
to view the width sonar
CALIBRATION function
2. Set with
the distance in mm between
the Sonar sensor (0 sonar) and the end of the di-
stance gauge(at rest)
A = Distance: Gauge at rest to
0 sonar
In the event of incorrect input in the width gauge calibration
function, press
to cancel it.
6.6 ADHESIVE WEIGHT WIDTH
Indicates the average width of the adhesive weights on the
market. Change ONLY if the width of the adhesive weights
used for unbalance correction /- 3 mm with respect
to that shown on the display (default=19mm).
Setup
