6
This tool has been specifi cally designed for cutting Copper or Aluminium cables.
DO NOT ATTEMPT TO CUT STEEL ROPES OR STEEL REINFORCED CONDUCTORS.
Do not use the tool for purposes other than those intended by
Cembre
.
The operator should concentrate on the work being performed and be careful to maintain a
balanced working position.
Work in a clean, uncluttered area. Keep persons away from immediate work area.
Inspect the blades before each use. Do not use damaged blades.
Damaged blades can break and cause injury or damage to the tool.
Before each use, verify the integrity of the tool; replace any worn, possibly damaged or missing
parts with original
Cembre
spares.
Wear eye protection. Metal chips can fl y from blades when cutting.
Do not cut live cables or conductors.
The tool is unsuitable for continuous use and should be allowed to cool down following uninter-
rupted, successive cutting operations; for instance, having exhausted a fully charged battery in
one session, delay battery replacement for a few minutes.
Protect the tool from rain and moisture. Water will damage the tool and battery. Electro-hydraulic
tools should not be operated in pouring rain.
The part reference includes the following:
Hydraulic cutting tool (B-TC950NA is fi tted with adapter to use Makita battery).
Li-Ion rechargeable battery (2 pcs) (model depends on the tool version).
Battery charger.
Shoulder strap.
Plastic carrying case.
USB cable (Ref. to § 5).
2. INSTRUCTIONS FOR USE
The tool can be easily carried using either the handle or the shoulder strap attached to ring (4)
(Ref. to Fig. 5).
Before starting any work, check the battery charge (Ref. to § 2.7) and recharge if necessary.
Refer to the manufacturer's instructions for the correct use of battery and battery charger.
WARNING
Summary of Contents for B-TC950A
Page 11: ...11...
