Cembre HT45, Operation And Maintenance Manual

3

ENGLISH

*

HYDRAULIC CRIMPING TOOLS

HT45  and  HT45-E

1.   GENERAL CHARACTERISTICS

–  Application range: 

suitable for installing electrical compression connectors for conductors up 

to 150 mm

2

 (300 MCM)

–

Crimping force:

 ......................................................................................................50 kN 

(6 sh ton)

–

Rated operating pressure:

 ..................................................................................600 bar 

(8,700 psi)

–

Dimensions: 

length ..............................................................................................346 mm 

(13.6 in.)

width - (handles closed) ..............................................................130 mm 

(5.1 in.)

width - (handles open) ................................................................250 mm 

(9.8 in.)

– Weight:

 (without dies) ..........................................................................................2 kg 

(4.4 lbs)

–

Oil recommended:

 .........................................................

AGIP ARNICA HI 32 

or

SHELL TELLUS OIL TX 32

or equivalent

–

Safety: 

the tool is provided with max pressure valve; 

MPC1

 special manometer, is available upon 

  request to check the correct setting of the valve.

2.  INSTRUCTIONS FOR USE 

2.1)  Preparation  

(Ref. to Fig. 2 and 3)

–  Select the appropriate die set for the connector.
–  Open the latch (22) and release the upper die holder (21).
–  Insert one die into the upper die holder (21) and one die into the lower die support (26).

Also, it should be considered that, in case of indent compression, the indentor PA... must be inserted 
in the die support (26), whereas the die MA... must be inserted in the upper die holder (21).

–  Close the latch.
–  Remove the handle holder (01) to release the moveable handle (36).

Ensure that the latch and the upper die holder are fully secured, otherwise damage may occur 
during tool operation.

–  Insert the conductor into connector.
–  Locate the connector between the dies at the desired crimp position.

2.2)  Die advancement

–  Operate the moveable handle (36) to build up pressure and 
  close the dies. 
  The automatic opening of the moveable handle allows the 
  operation of the tool using one hand, while locating the con-
  nector in the desired crimp position with the other hand.

*  

The 

HT45-E

 tool is the 

HT45

 tool fitted with the plastic case type 

VAL P1

.