2
LABEL SYMBOLS
Before using the tool,
carefully read the in-
structions in this manual.
When operating the
tool, keep hands away
from the danger zone.
THIS HEAD CONTAINS
NON-CONDUCTIVE OIL
RHC131LN-KV
130 kN (14.6 tons)
TYPE
E
C
R
O
F
MAX.
PRESSURE
Made in Italy
700 bar (10,000 psi)
1.
GENERAL CHARACTERISTICS
Presshead:
"C" shaped with large jaw opening (1,65 inch) with external coatings
Application range:
suitable for installing electrical compression
connectors on conductors up to:
mm
2
(MCM)
400 (800)
Crimping force
kN (tons)
130 (14.6)
Max operating pressure
bar (psi)
700 (10,000)
Oil necessary
(displacement)
cm
3
(cu. in.)
80 (4.8)
Weight
kg (lbs)
5,9 (13)
Dimensions
length x width
mm (in.)
308 (12.1) x 133 (5.2)
The presshead is provided with additional external coatings to protect the operator and
tool against accidental brush contact with live conductors.
Proper training techniques and practices should always be adhered to when working
around live conductors.
Always consult your company’s work rules and methods to select suitable tooling, rubber
insulated gloves, shrouding and other protective equipment.
Under no circumstances should operatives rely solely on the insulating properties of the
tools alone when working around live conductors.
Prior to use please ensure the head and specifi cally the insulating protection are not
damaged.
Never pressurise the presshead without inserting the dies, this could cause damage to the
head and the ram.
To connect the presshead to the hydraulic drive pump, use only the specifi c insulated
fl exible hose provided with the head.
The oil pressure in the presshead must always be completely released before discon-
necting it from the fl exible hose.
WARNING!
Do not operate
when dies are
n o t i n p l a c e .
