36
4.4.2) Taladradora equipada con mandril “MND 1”
– Soltar inmediatamente el boton (07).
– Accionar la palanca de emergencia (09) moviéndola hacia abajo para provocar así el desen-
ganche inmediato de la broca de la taladradora y poder alejar esta última inmediatamente.
5. CAMBIO DEL MANDRIL
(Ref. Fig. 1 y 2)
Para usar brocas con macho de unión de 16 mm Ø, es preciso utilizar el mandril “MND 1” inter-
cambiable con el mandril estándar “MND”.
El cambio de mandril se efectúa de la manera siguiente:
5.1) Desmontaje del mandril “MND”
– Quitar la protección móvil (19) (véase § 4.1.2).
– Quitar la broca (véase § 4.1.1).
– Quitar la protección fija (21) haciendo girar con fuerza toda la carcasa hasta vencer la acción
de retención de las dos bolas con muelle (25); se desengancha así de las clavijas (27) y se puede
extraer fácilmente, dejando visible el árbol mandril (12).
– Quitar el tornillo (15) de fijación del mandril en el árbol mandril (12) con la llave Allen de 4 mm
suministrada con el equipamiento estándar.
– Quitar el aro elástico (13) hasta poder extraer el perno (14) que une el mandril al árbol (10) de
disparo del mandril y sacar el mandril.
5.2) Montaje del mandril “MND 1”
– Insertar el mandril “MND1” sobre el árbol mandril (12) orientándolo de manera que la lengüeta
de arrastre (16) del mandril se introduzca en el asiento correspondiente en el árbol mandril.
– Alinear el agujero situado en el árbol (10) de la palanca de emergencia con los agujeros co-
rrespondientes del mandril.
– Insertar el perno (14) de acoplamiento del mandril en el árbol (10) de la palanca de emergencia
y bloquearlo con el aro elástico correspondiente (13).
– Apretar a fondo el tornillo (15) de sujeción del mandril sobre el árbol mandril (12).
– Volver a montar la protección fija (21).
– Volver a montar la broca con macho de unión de 16 mm Ø (véase § 5.3) volver a montar la
protección móvil (19) (véase § 4.1.2).
5.3) Montaje (y desmontaje) de las brocas en el mandril “MND 1”
– Girar completamente la palanca de emergencia (09) y manteniéndola en esta posición insertar
a fondo el macho de la broca en el agujero correspondiente del mandril.
Para insertar el macho rápida y correctamente en
el asiento correspondiente del mandril, mantener
alineadas las dos improntas presentes en el macho
con la línea roja de referencia dibujada en la parte
terminal del mandril.
– Soltar la palanca de emergencia (09).
Para desmontar la broca es suficiente tirar de ella
con fuerza después de girar completamente la
palanca de emergencia (09).
ESPAÑOL
Grooves on
the auger
Red reference line
on the spindle