GB
Figure 6.2.2.1: Installation
of pusher
E
Figure 6.2.3: Hopper attachment for SW 200
6.2.2 Pusher / remote control (optional))
1. Mount pusher onto base frame with supplied
screw
E
.
Optional remote control:
1. Mount the pusher onto base frame with supplied
screw
F
.
2. Mount the handle holder onto towing vehicle with
supplied screw
G
.
2. Mount the level in the holder with supplied
clamping screw
H
.
6.2.3 Hopper attachment
1. Place the three hopper attachment segments
(top pointing downwards) in a circle following the
numbering on the segments (see figure 6.2.3).
2. First, use only 2 screws, 4 washers and 2 nuts to
connect each pair of segments, but do not tighten
yet. Connect the three segments in this way.
Note:
The connection of the segments is not yet rigid,
which simplifies installation into the base hopper.
3. Turn the hopper attachment ring the right way up
and mount onto the base hopper.
4. Align the hopper attachment ring with one segment
edge in the direction of the drawbar and use the
remaining screws, washers and nuts to connect
the segments and make the connection between
the hopper attachment and the base hopper
Segment edge
Drawbar
5. Tighten all connection screws.
6.2.4 Lighting
1. Remove the 4 nuts and 4 serrated washers from
the two rear lights.
2. Mount the rear light with the plug cable on the left
in the direction of travel (large washer above the
long slot, then the serrated washer and the nut).
3. Secure the cables of the rear lights (see figure
5.1.1) with cable ties.
4. Trim the ends of the cable ties with side cutters.
5. Plug the 7-pin vehicle plug into the towing vehicle
and perform a function test.
6.2.5 Spreading range limiter (optional)
1. Mount the spreading range limiter onto the base
frame with screws
I
.
Figure 6.2.5:
Spreading range limiter
Figure 6.2.2.2: Installation
of remote control
F
G
I
H
Numbering of the segments approx. 7 cm below
the edge -> matching numbers align.
18
Summary of Contents for SW200
Page 35: ...F 35 ...
Page 36: ...36 D GB GB GB F ...
Page 38: ...Notizen 38 ...
Page 39: ...Notizen 39 ...
