Page 9
For technical questions, please call 1-800-444-3353.
Item 69662
maintenance and Servicing
procedures not specifically explained in this manual must
be performed only by a qualified technician.
tO pRevent SeRiOuS inJuRY FROm aCCiDental OpeRatiOn:
make sure that all loads are disconnected from the inverter, the power Switch is in the off-position and
the cables are disconnected from power source before performing any procedure in this section.
tO pRevent SeRiOuS inJuRY FROm tOOl FailuRe:
Do not use damaged equipment. if abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, maintenance, and lubrication
1.
BeFORe eaCh uSe,
inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• damaged cord/electrical wiring,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2.
aFteR uSe,
wipe external surfaces
of the tool with clean cloth.
3. Maintain batteries according to manufacturer’s
instructions. Check electrolyte level on all
batteries after charging and refill as needed.
Charge batteries according to manufacturer’s
recommendations OnlY;
incorrect charging
may cause battery damage or explosion.
4.
DO nOt Open hOuSinG.
Contains no user-serviceable parts.
internal parts may be electrified, even
with unit off and power disconnected.
5. Internal electronic components must be
disposed of properly or recycled.
Sa
Fet
Y
Ope
R
ati
O
n
m
aintenan
C
e
Setup
Summary of Contents for 69662
Page 1: ......
