Page 3
SKU 96497
For technical questions, please call 1-800-444-3353.
Take caution as some woods contain preservatives such as copper chromium
arsenate (CCA) which can be toxic. When working with these materials extra care
should be taken to avoid inhalation and minimize skin contact.
Take care when handling the Moisture Meter. The probes of the Moisture Meter are
sharp.
The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
unpacking
When unpacking, check to make sure the parts shown the Parts List are included. If any parts
are missing or broken, please call Harbor Freight Tools at the number on the cover of this
manual as soon as possible.
operating
Remove the rear battery panel and insert a nine volt battery making sure the positive
(+) and negative (-) polarities on the battery match the polarities in the battery case.
Push the Power Button.
Remove the Probe Cap. To test the unit, place fingers on the
outside of the pins and apply light pressure, as shown to the
right. Be careful, the pins are sharp. The unit should read at
about 30% after a few moments.
Make sure there are no utility lines, wires, nails, or screws under
the surface of the material to be measured.
To measure moisture content, insert the Spikes into the material
approximately 1/4 inch (5mm) deep.
Allow the readout to settle on a number, and push the HOLD
button to lock the number.
When finished, push the Power button and place Probe Cover back on the unit be
-
fore storing.
maintenance
Keep the unit dry and clean. Wipe clean with moist cloth as needed.
When the digital display shows this icon:
, the battery must be changed. Follow
the directions in Step 1 under the Operating section to replace the battery. Dispose
of used batteries as appropriate for type according to State, Local and Federal laws
and regulations.
8.
9.
10.
1.
2.
3.
4.
5.
6.
7.
1.
2.
