ICS Smart Indoor Repeater
CenRF Communications Limited
www.cenrf.com
Page 8 of 13
2 Device Debugging
2.1 Preparation
Detail of Preparation
Description
Data cable
USB data cable
Computer
Computer
Configuration interface of
overall unit
ICS debugging software
(PICO_ICS_TOOL_EN.exe)
2.2 Device Debugging
Connect the module to the power adapter, approx. 20 seconds later start up the module, then
connect USB data cable to the USB port of the computer and the overall unit and open the
ICS debugging interface.
Open the ICS debugging software (PICO_ICS_TOOL_EN.exe) interface. In case of
connection failure due to incorrect setting of serial ports, the software would pop up a dialog
box indicating connection failure. Then select the current computer’s serial port in the options
of serial port configuration. You may view the computer port in the operating sequence
(computer
—— attribute —— hardware —— device manager —— port). The serial port’s
baud rate is 460800 and serial port’s configuration is shown in Figure 2.2.1. once selected
properly, you may view the monitoring interface and in case of connection failure, the basic
data of monitoring interface would be read out. Only after the serial port was properly
configured could sequent operation proceed.
Figure 2.2.1
The settings of module’s monitoring interface for reference are detailed as follows:
The following screenshot is data reading in the setting of application for reference. Please
refer to the instruction concerning the use of this interface behind each screen shot in the
configuration.