1 0
1 0
SQUARE 200PZ User Manual
Eng
3) Power Input/Output Sockets
Plug the power-cord included with SQUARE 200PZ into an AC socket properly con-
figured for this fixture. Please read “5.2. About Power Connection” on page 10 for
details. This fixture is also equipped with an output power connector to be used as
power mains source in case of
cascade connection up to a maximum of 5 fix-
tures
.
1st Unit
5th Unit
4th Unit
3rd Unit
2nd Unit
Power Input
100-240Vac - 50/60Hz
4) DMX Input/Output Sockets
DMX Input is a 3-pin male XLR socket for connection to a DMX control device. DMX
output is a3-pin female socket for sending the DMX control signal to other units.
Please read “5.3. About Dmx Connection” on page 11 for details on how to man-
age DMX connections.
5.2.
About Power Connection
y
Always make sure that the voltage of the outlet you are connecting the product
to is within the range stated in paragraph “10 - Specification” on page 18 or
rear panel of the product (AC110V-240V 50/60Hz).
y
Make sure the power cord is not crimped or damaged. Never connect this prod-
uct to a dimmer pack or rheostat.
y
Never disconnect the product from power cord by pulling or tugging on the cord.
y
To avoid electric shock, all fixtures must be connected to circuits with a suitable
ground and circuit breaker.
y
Wire correspondence is as follows:
Cable (EU)
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
Earth must be connected! Always pay attention to safety! Before taking into
operation for the first time, the installation has to be approved by an expert.
