11
11
MOODLINER 1812WP User Manual
Eng
5-Pin XLR and 3-Pin XLR system. If you wish to connect this fixture to a 5-Pin XLR in-
put fixture, you need to use an adapter-cable or make it by yourself. Below you can
see the wiring correspondence between 3-Pin and 5-Pin plug and socket standards
5-Pins XLR (plug)
Pin 1: GND (Screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
Pin 4: N/C
Pin 5: N/C
3-Pins XLR (socket)
Pin 1: GND (Screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
5-Pins XLR (socket)
Pin 1: GND (Screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
Pin 4: N/C
Pin 5: N/C
3-Pins XLR (plug)
Pin 1: GND (Screen)
Pin 2: Signal (-)
Pin 3: Signal (+)
6 - M
enu
o
PeraTion
By pressing MENU button, the display will cycle through 15 menus. Press ENTER but-
ton to enter the corresponding menu, press UP or DOWN to modify current parame-
ter value. Then, press ENTER button again to save current value.
Menu N.
Menu Name
Description
1
A001 - A255
DMX Channel Address Selection
2
23CH/9CH/72CH Channel Mode Selection. You can choose among 9CH, 23CH or
72CH modes
3
CC00-CC99
This is an automatic mode. The LED bar is fully lit and the effect
is the jump between the different colors with the speed set by
the user (0 ÷ 99) by using the UP and DOWN buttons.
4
Ed00-Ed99
This is an automatic mode. The LED bar is fully lit and the tran-
sition between colors occurs cyclically with fades and pulses.
The User can set the transition speed (0 ÷ 99) by using the UP
and DOWN buttons.
5
Er00-Er99
This is an automatic mode. The LED bar is fully lit and the
transition between colors occurs by changing the color to each
individual LED creating a scrolling effect. The User can set the
scrolling/transition speed (0 ÷ 99) by using the UP and DOWN
buttons.
6
Po00-Po99
Like the automatic mode above, the LED bar is fully lit and the
transition between colors takes place with a mix of effects
of fades, impulses and scrolling. The User can set the effects
speed (0 ÷ 99) by using the UP and DOWN buttons.
7
tr00-tr14
This function allows selection between 15 different automatic
modes (0 ÷ 14) with scroll effects and color combinations. Se-
lection is made by using the UP and DOWN buttons.
8
tU00-tU99
This function allows to set the speed (0 ÷ 99) of the “RUNNING
CHANGE MODE” selected. The speed setting can be done
using the UP and DOWN buttons.
